Survey of lift-fan aerodynamic technology

Representatives of NASA Ames Research Center asked that a summary of technology appropriate for lift-fan powered short takeoff/vertical landing (STOVL) aircraft be prepared so that new programs could more easily benefit from past research efforts. This paper represents one of six prepared for that purpose. The authors have conducted or supervised the conduct of research on lift-fan powered STOVL designs and some of their important components for decades. This paper will first address aerodynamic modeling requirements for experimental programs to assure realistic, trustworthy results. It will next summarize the results or efforts to develop satisfactory specialized STOVL components such as inlets and flow deflectors. It will also discuss problems with operation near the ground, aerodynamics while under lift-fan power, and aerodynamic prediction techniques. Finally, results of studies to reduce lift-fan noise will be presented. The paper will emphasize results from large scale experiments, where available, for reasons that will be brought out in the discussion. Some work with lift-engine powered STOVL aircraft is also applicable to lift-fan technology and will be presented herein. Small-scale data will be used where necessary to fill gaps.

[1]  E. G. Smith.  Cascade tests of serrated leading edge blading at high subsonic speeds , 1974 .

[2]  Kenneth W. Mort.  Summary of Large-Scale Tests of Ducted Fans , 1966 .

[3]  G. L. Gentry,et al.  Jet-induced lift losses on VTOL CONFIGURATIONS hovering in and out of ground effect , 1966 .

[4]  David H. Hickey,et al.  Aerodynamic Characteristics of a Large-Scale Model with a High Disk-Loading Lifting Fan Mounted in the Fuselage , 1961 .

[5]  Paul F. Yaggy,et al.  Aerodynamic Characteristics of a 4-foot-diameter Ducted Fan Mounted on the Tip of a Semispan Wing , 1962 .

[6]  B. K. Hodder,et al.  Aerodynamic characteristics of a large-scale model with a lift fan mounted in a 5 per cent thick triangular wing, including the effects of BLC on the lift fan inlet , 1970 .

[7]  V. R. Corsiglia,et al.  Wind-tunnel test of a full-scale, 1.1 pressure ratio, ducted lift-cruise fan , 1964 .

[8]  J. P. Barrack,et al.  Reingestion Characteristics and Inlet Flow Distortion of V/STOL Lift-Engine Fighter Configurations , 1969 .

[9]  J. V. Kirk,et al.  Aerodynamic characteristics of a V/STOL TRANSPORT model with lift and lift-cruise fan power plants , 1966 .

[10]  Z. J. Przedpelski.  Lift fan technology studies , 1967 .

[11]  J. H. Diedrich.  Summary of model VTOL lift fan tests conducted at NASA Lewis Research Center , 1975 .

[12]  David H Hickey,et al.  Aerodynamics of V/STOL aircraft powered by lift fans , 1967 .

[13]  S. B. Schmidt.  Hover test results of a small-scale twin-tilt nacelle model , 1985 .

[14]  M. S. Reinath,et al.  Laser velocimetry in the low-speed wind tunnels at Ames Research Center , 1984 .

[15]  M. W. Kelly,et al.  Characteristics of two large-scale jet-lift propulsion systems , 1966 .

[16]  D. L. Stimpert.  Effect of crossflow velocity on VTOL lift fan blade passing frequency noise generation , 1973 .

[17]  D. W. Esker.  Ground test of the D shaped vented thrust vectoring nozzle , 1976 .

[18]  P. T. Soderman,et al.  Leading edge serrations which reduce the noise of low-speed rotors , 1973 .