Cleavage Fracture of Brittle Semiconductors from the Nanometre to the Centimetre Scale

The objective of this paper is to present the fundamental phenomena occurring during the scribing and subsequent fracturing process usually performed when preparing surfaces of brittle semiconductors. In the first part, an overview of nano-scratching experiments of different semiconductor surfaces (InP, Si and GaAs) is given. It is shown how phase transformation can occur in Si under a diamond tip, how single dislocations can be induced in InP wafers and how higher scratching load of GaAs wafer leads to the apparition of a crack network below the surface. A nano-scratching device, inside a scanning electron microscope (SEM), has been used to observe how spalling (crack and detachment of chips) and/or ductile formation of chips may happen at the semiconductor surface. In the second part cleavage experiments are described. The breaking load of thin GaAs (100) wafers is directly related to the presence of initial sharp cracks induced by scratching. By performing finite element modelling (FEM) of samples under specific loading conditions, it is found that the depth of the median crack below the scratch determines quantitatively the onset of crack propagation. By carefully controlling the position and measuring the force during the cleavage, it is demonstrated that crack propagation through a wafer can be controlled. Besides, the influence of the loading configuration on crack propagation and on the cleaved surface quality is explained. © 2005 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.

[1]  Harry L. Swinney,et al.  Dynamic Fracture in Single Crystal Silicon , 1999 .

[2]  B. Lawn.  Fracture of Brittle Solids by Brian Lawn , 1993 .

[3]  M. Azzaz,et al.  Plastic deformation, extended stacking faults and deformation twinning in single crystalline indium phosphide. 2. S doped InP , 1994 .

[4]  H. Leipner,et al.  Pop-in effect as homogeneous nucleation of dislocations during nanoindentation , 2003 .

[5]  Non-linear dynamical analysis of crack surface perturbations and their dependence on velocity and direction , 2004 .

[6]  S. J. Lloyd,et al.  Deformation under nanoindents in Si, Ge, and GaAs examined through transmission electron microscopy , 2001 .

[7]  T. Rouxel,et al.  Surface damage of soda–lime–silica glasses: indentation scratch behavior , 2003 .

[8]  Low-load deformation of InP under contact loading; comparison with GaAs , 2002 .

[9]  Sabri Cetinkunt,et al.  Raman microspectroscopy analysis of pressure-induced metallization in scratching of silicon , 2001 .

[10]  Staffan Jacobson,et al.  Failure mode analysis of TiN-coated high speed steel: In situ scratch adhesion testing in the scanning electron microscope , 1990 .

[11]  Michael V. Swain,et al.  In situ electrical characterization of phase transformations in Si during indentation , 2003 .

[12]  C. Ballif,et al.  Selective etching of n-InP(1 0 0) triggered at surface dislocations induced by nanoscratching , 2006 .

[13]  E. Felder,et al.  Mechanical analysis of the scratch test on elastic and perfectly plastic materials with the three-dimensional finite element modeling , 2001 .

[14]  E. Bourhis,et al.  Deformations induced by a Vickers indentor in InP at room temperature , 2000 .

[15]  M. Swain,et al.  Mechanical deformation in silicon by micro-indentation , 2001 .

[16]  Y. B. Xu,et al.  Shear-activated indentation crack in GaAs single crystal , 2001 .

[17]  E. Felder,et al.  Experimental and Three-Dimensional Finite Element Study of Scratch Test of Polymers at Large Deformations , 2004 .

[18]  É. Tournié,et al.  RAPID COMMUNICATION: Nanoindentation of Si, GaP, GaAs and ZnSe single crystals , 2003 .

[19]  Fracture mechanisms of GaAs under nanoscratching , 2004 .

[20]  P. Gasser,et al.  Defect-free AFM scratching at the Si/SiO2 interface used for selective electrodeposition of nanowires , 2004 .

[21]  Shearing orientation dependence of cleavage step structures on GaAs(110) , 2000 .

[22]  M. Hanson.  The Elastic Field for Spherical Hertzian Contact Including Sliding Friction for Transverse Isotropy , 1992 .

[23]  M. Hanson,et al.  The Elastic Field for Spherical Hertzian Contact of Isotropic Bodies Revisited: Some Alternative Expressions , 1993 .

[24]  A. A. Griffith.  The Phenomena of Rupture and Flow in Solids , 1921 .

[25]  Huajian Gao,et al.  Hyperelasticity governs dynamic fracture at a critical length scale , 2003, Nature.

[26]  A. Heinrich,et al.  Nonlinear dynamic instability in brittle fracture of GaAs , 1999 .

[27]  Hans Joachim Möller,et al.  Basic Mechanisms and Models of Multi‐Wire Sawing , 2004 .

[28]  P. Gumbsch,et al.  Influence of crack propagation direction on {110} fracture toughness of gallium arsenide , 1998 .

[29]  M. Swain,et al.  Pop-in events induced by spherical indentation in compound semiconductors , 2004 .

[30]  D. Hull,et al.  Fractography: Observing, Measuring and Interpreting Fracture Surface Topography , 1999 .

[31]  Process-induced stress and microcrack nucleation in GaAs wafers , 1998 .

[32]  Patrick Schwaller,et al.  Observation of fracture and plastic deformation during indentation and scratching inside the scanning electron microscope , 2004 .

[33]  Michael P Marder,et al.  Ideal Brittle Fracture of Silicon Studied with Molecular Dynamics , 1998 .