Adaptive power controllable retrodirective array system for wireless sensor server applications

An adaptive power controllable retrodirective array system is presented. It is able to conserve battery power in an idle mode and wake up only when it needs to operate, extending the array system's lifetime. One application of this technology is for use as wireless sensor servers, which act as a relay point between wireless sensors and remote data collectors. The proposed retrodirective array is fabricated and tested at 5.8 GHz and uses an integrated rectenna and an analog switch, which controls a battery power source. When an RF signal is received by the antenna array, it is split between a rectenna and receiver (RX), where most power is sent to a rectenna. The collected dc voltage wakes up the system by activating a switch connected to a battery and the RX. When there is no interrogation, the switch turns off. Furthermore, the second and third harmonic rejection characteristic of a circular sector antenna is introduced so that it makes the system simpler by eliminating a low-pass filter in the rectenna. For the phase-conjugation retrodirective array, second subharmonic mixers are used by employing antiparallel diode pairs, which enables avoiding expensive high-frequency oscillators. It is experimentally demonstrated that the retrodirective array system with the proposed power management can retransmit the received signal toward the source when the received power is greater than -8.5dBm. Application of the retrodirective array system as a multifunctional RX array is also investigated.

[1]  Gregory J. Pottie,et al.  Integrated low-power communication system design for wireless sensor networks , 2004, IEEE Communications Magazine.

[2]  Vincent Fusco,et al.  Balanced subharmonic mixers for retrodirective-array applications , 2001 .

[3]  R. A. Burberry,et al.  Antenna problems in RFID systems , 1999 .

[4]  N. Chubachi,et al.  Transcutaneous DC-DC converter for totally implantable artificial heart using synchronous rectifier , 1996 .

[5]  Sang-Min Han,et al.  Dual-fed circular sector antenna system for a rectenna and a RF receiver , 2004, 34th European Microwave Conference, 2004..

[6]  Itoh,et al.  A rectenna design with harmonic-rejecting circular-sector antenna , 2004, IEEE Antennas and Wireless Propagation Letters.

[7]  Hamid Sharif,et al.  Study of an adaptive frame size predictor to enhance energy conservation in wireless sensor networks , 2005, IEEE Journal on Selected Areas in Communications.

[8]  Sungjoon Lim,et al.  Adaptive power controllable retrodirective array system for portable battery-operated applications , 2005, IMS 2005.

[9]  L. Pon,et al.  Retrodirective array using the heterodyne technique , 1964 .

[10]  Hung-Wei Chen,et al.  A low power and fast wake up circuit , 2004, 2004 IEEE International Symposium on Circuits and Systems (IEEE Cat. No.04CH37512).

[11]  Jean Michel Daga,et al.  Design techniques for EEPROMs embedded in portable systems on chips , 2003, IEEE Design & Test of Computers.

[12]  Alessandro Trifiletti,et al.  A low-power microcontroller with on-chip self-tuning digital clock-generator for variable-load applications , 1999, Proceedings 1999 IEEE International Conference on Computer Design: VLSI in Computers and Processors (Cat. No.99CB37040).

[13]  Abraham O. Fapojuwo,et al.  A centralized energy-efficient routing protocol for wireless sensor networks , 2005, IEEE Communications Magazine.

[14]  Wojciech E. Kozlowski,et al.  Synchronizing low-cost energy aware sensors in a short-range wireless cell , 2001, Proceedings Euromicro Symposium on Digital Systems Design.

[15]  Tsutomu Miyasaka,et al.  Tin-Based Amorphous Oxide: A High-Capacity Lithium-Ion-Storage Material , 1997 .

[16]  Yian Chang,et al.  Microwave phase conjugation using antenna arrays , 1998 .

[17]  Naoki Shinohara,et al.  Dependence of dc output of a rectenna array on the method of interconnection of its array elements , 1998 .

[18]  R. A. Smith Electronic Circuits , 1949, Nature.

[19]  John A. Stankovic,et al.  Radio-triggered wake-up capability for sensor networks , 2004, Proceedings. RTAS 2004. 10th IEEE Real-Time and Embedded Technology and Applications Symposium, 2004..

[20]  Stuart A. Long,et al.  A theoretical and experimental investigation of annular, annular sector, and circular sector microstrip antennas , 1984 .

[21]  M. Rodwell,et al.  An ultra-low power InAs/AlSb HEMT Ka-band low-noise amplifier , 2004, IEEE Microwave and Wireless Components Letters.

[22]  R. Zane,et al.  Recycling ambient microwave energy with broad-band rectenna arrays , 2004, IEEE Transactions on Microwave Theory and Techniques.

[23]  Ralph Helmar Rasshofer,et al.  Circularly polarized millimeter-wave rectenna on silicon substrate , 1998 .

[24]  Yuanxun Wang,et al.  Digital wireless sensor server using an adaptive smart-antenna/retrodirective array , 2003, IEEE Trans. Veh. Technol..

[25]  Kai Chang,et al.  A high-efficiency dual-frequency rectenna for 2.45- and 5.8-GHz wireless power transmission , 2002 .

[26]  C. Smaltz Extending battery life of portable devices , 1993, Proceedings of WESCON '93.