Biofilm Structure and Extracellular Polymeric Substances in Low and High Dissolved Oxygen Membrane Bioreactors

Abstract This paper discusses the effect of dissolved oxygen (DO) on the biofilm structure in membrane bioreactor (MBR) and their consequence on membrane permeability and EPS. Two MBRs under high DO (6.0 mg/L, HDO) and low DO (<0.1 mg/L, LDO) were operated in parallel under same hydrodynamic conditions. The microbiological aspects in MBR systems were explored through a series of analysis techniques including PCR‐DGGE, gel filtration chromatography (GFC), confocal laser scanning microscope (CLSM), and image analysis. The rate of membrane fouling for the LDO MBR was 5 times faster than that for the HDO MBR. The microbial communities between HDO and LDO MBR were quite different, which is likely to be the reason for different structures and permeabilities of the biofilms. The specific biofilm resistance in HDO MBR was lower to that in LDO MBR. This is attributed to relatively lower porosity and higher amount of EPS for the biofilm in LDO MBR. The distributions of cell and EPS were not uniform in the biofilms in both HDO and LDO MBR. The biofilm in LDO MBR contained larger amount of EPS than that in HDO MBR. The ratio of protein to polysaccharide was also higher for biofilm in HDO MBR than in LDO MBR.

[1]  H. H. Fang,et al.  Pore fouling of microfiltration membranes by activated sludge , 2005 .

[2]  Hang-Sik Shin,et al.  Sludge characteristics and their contribution to microfiltration in submerged membrane bioreactors , 2003 .

[3]  Y. Magara,et al.  The Effect of Operational Factors on Solid/Liquid Separation by Ultra-Membrane Filtration in a Biological Denitrification System for Collected Human Excreta Treatment Plants , 1991 .

[4]  A. E. Greenberg,et al.  Standard methods for the examination of water and wastewater : supplement to the sixteenth edition , 1988 .

[5]  Haluk Beyenal,et al.  Three-dimensional biofilm structure quantification. , 2004, Journal of microbiological methods.

[6]  K. Keiding,et al.  Extraction of extracellular polymers from activated sludge using a cation exchange resin , 1996 .

[7]  B. Wilén,et al.  The effect of dissolved oxygen concentration on the structure, size and size distribution of activated sludge flocs , 1999 .

[8]  Awwa,et al.  Standard Methods for the examination of water and wastewater , 1999 .

[9]  Chung‐Hak Lee,et al.  Characteristics of microfiltration membranes in a membrane coupled sequencing batch reactor system. , 2003, Water research.

[10]  D. Hempel,et al.  Volumetric measurements of bacterial cells and extracellular polymeric substance glycoconjugates in biofilms. , 2004, Biotechnology and bioengineering.

[11]  Kyung-Min Yeon,et al.  Characterization of biofilm structure and its effect on membrane permeability in MBR for dye wastewater treatment. , 2006, Water research.

[12]  K. Ishiguro,et al.  EFFECTS OF BIOLOGICAL TREATMENT CONDITIONS ON PERMEATE FLUX OF UF MEMBRANE IN A MEMBRANE/ACTIVATED-SLUDGE WASTEWATER TREATMENT SYSTEM , 1994 .

[13]  S. Okabe,et al.  In Situ Analysis of Nitrifying Biofilms as Determined by In Situ Hybridization and the Use of Microelectrodes , 1999, Applied and Environmental Microbiology.

[14]  Anthony G. Fane.  Membranes for water production and wastewater reuse , 1996 .

[15]  I. Chang,et al.  Correlation between dissolved oxygen concentration, microbial community and membrane permeability in a membrane bioreactor , 2006 .

[16]  K. Choo,et al.  Hydrodynamic behavior of anaerobic biosolids during crossflow filtration in the membrane anaerobic bioreactor , 1998 .

[17]  Chung‐Hak Lee,et al.  Effect of aerobic period on microfiltration performance in a membrane-coupled sequencing batch reactor , 2004 .

[18]  Jost Wingender,et al.  Application of fluorescently labelled lectins for the visualization and biochemical characterization of polysaccharides in biofilms of Pseudomonas aeruginosa. , 2002, Journal of microbiological methods.

[19]  J. Lawrence,et al.  Lectin-binding analysis in biofilm systems. , 1999, Methods in enzymology.

[20]  Rui Liu,et al.  Behaviour of soluble microbial products in a membrane bioreactor , 2000 .

[21]  J. Caro,et al.  Basic Principles of Membrane Technology , 1998 .

[22]  In-Soung Chang,et al.  Membrane filtration characteristics in membrane-coupled activated sludge system -- the effect of physiological states of activated sludge on membrane fouling , 1998 .

[23]  P. Lant,et al.  Impacts of morphological, physical and chemical properties of sludge flocs on dewaterability of activated sludge , 2004 .

[24]  F. Smith,et al.  Colorimetric Method for Determination of Sugars and Related Substances , 1956 .

[25]  Jong-sang Park,et al.  Removal of soluble COD by a biofilm formed on a membrane in a jet loop type membrane bioreactor. , 2005, Water research.

[26]  Chung‐Hak Lee,et al.  Comparison of the filtration characteristics between attached and suspended growth microorganisms in submerged membrane bioreactor. , 2001, Water research.

[27]  Simon Judd,et al.  Impact of aeration, solids concentration and membrane characteristics on the hydraulic performance of a membrane bioreactor , 2003 .

[28]  Waite,et al.  Colloidal Fouling of Ultrafiltration Membranes: Impact of Aggregate Structure and Size. , 1999, Journal of colloid and interface science.