Local thermal–hydraulic behaviour in tight 7-rod bundles

Abstract Advanced water-cooled reactor concepts with tight lattices have been proposed worldwide to improve the fuel utilization and the economic competitiveness. In the present work, experimental investigations were performed on thermal–hydraulic behaviour in tight hexagonal 7-rod bundles under both single-phase and two-phase conditions. Freon-12 was used as working fluid due to its convenient operating parameters. Tests were carried out under both single-phase and two-phase flow conditions. Rod surface temperatures are measured at a fixed axial elevation and in various circumferential positions. Test data with different radial power distributions are analyzed. Measured surface temperatures of unheated rods are used for the assessment of and comparison with numerical codes. In addition, numerical simulation using sub-channel analysis code MATRA and the computational fluid dynamics (CFD) code ANSYS-10 is carried out to understand the experimental data and to assess the validity of these codes in the prediction of flow and heat transfer behaviour in tight rod bundle geometries. Numerical results are compared with experimental data. A good agreement between the measured temperatures on the unheated rod surface and the CFD calculation is obtained. Both sub-channel analysis and CFD calculation indicates that the turbulent mixing in the tight rod bundle is significantly stronger than that computed with a well established correlation.

[1]  D. Chang,et al.  Numerical simulation of turbulent flow in a 37-rod bundle , 2007 .

[2]  Y. Oka.  Design concept of once-through cycle supercritical-pressure light water cooled reactors , 2000 .

[3]  Xiaojing Liu,et al.  A MIXED CORE FOR SUPERCRITICAL WATER-COOLED REACTORS , 2008 .

[4]  R. Azad,et al.  The structure of turbulent flow in triangular array rod bundles , 1975 .

[5]  Werner Oldekop,et al.  General Features of Advanced Pressurized Water Reactors with Improved Fuel Utilization , 1982 .

[6]  D. Chang,et al.  Unsteady Numerical Simulations of Turbulence and Coherent Structures in Axial Flow Near a Narrow Gap , 2005 .

[7]  T. Gatski,et al.  Modelling the pressure–strain correlation of turbulence: an invariant dynamical systems approach , 1991, Journal of Fluid Mechanics.

[8]  Kye Bock Lee,et al.  A numerical prediction on the turbulent flow in closely spaced bare rod arrays by a nonlinear k−ϵ model , 1997 .

[9]  George Yadigaroglu,et al.  Trends and needs in experimentation and numerical simulation for LWR safety , 2003 .

[10]  U. Müller,et al.  Critical heat flux and turbulent mixing in hexagonal tight rod bundles , 1998 .

[11]  L. Meyer,et al.  Experimental investigation of turbulent transport of momentum and energy in a heated rod bundle , 1998 .

[12]  A. D. Gosman,et al.  The prediction of fully developed axial turbulent flow in rod bundles , 1986 .

[13]  J. Hooper,et al.  Large-scale structural effects in developed turbulent flow through closely-spaced rod arrays , 1984, Journal of Fluid Mechanics.

[14]  Xu Cheng,et al.  CFD analysis of thermal–hydraulic behavior of heavy liquid metals in sub-channels , 2006 .

[15]  X. Cheng,et al.  Experimental studies on critical heat flux in vertical tight 37-rod bundles using freon-12 , 2005 .

[16]  S. Tavoularis,et al.  The structure of turbulent flow in a rectangular channel containing a cylindrical rod – Part 2: phase-averaged measurements , 2000 .

[17]  K. Rehme,et al.  The structure of turbulence in rod bundles and the implications on natural mixing between the subchannels , 1992 .

[18]  Brian J. Cox,et al.  HIGH BURNUP FUEL ISSUES , 2008 .

[19]  D. Chang,et al.  Convective Heat Transfer in Turbulent Flow Near a Gap , 2006 .

[20]  H. Ninokata,et al.  A turbulence model study for simulating flow inside tight lattice rod bundles , 2005 .