Measurement of the Mass and Rigidity of Adsorbates on a Microcantilever Sensor

When microcantilevers are used in the dynamic mode, the resonance shift upon material adsorption depends on the position of the adsorbate along the microcantilever. We have previously described that the adsorbate stiffness needs to be considered in addition to its mass in order to correctly interpret the resonance shift. Here we describe a method that allows obtaining the Young's modulus of the adsorbed bacteria derived from the measurement of the frequency shift when adsorbates are placed close to the clamping region. As a model system we have used E. Coli bacteria deposited on the cantilever surface by the ink-jet technique. We demonstrate that the correct information about adsorbed mass can be extracted by recording the cantilever profile and its resonance response. Also, the position and extent of adsorbates is determined by recording the microcantilever profile. We use a theoretical model based on the Euler – Bernouilli equation for a beam with both mass and flexural rigidity local increase due to the deposited material.

[1]  Ernst Meyer,et al.  Dynamics of damped cantilevers , 2000 .

[2]  Panos G. Datskos,et al.  Remote optical detection using microcantilevers , 1996 .

[3]  J. Sader,et al.  Method for the calibration of atomic force microscope cantilevers , 1995 .

[4]  T. Thundat,et al.  Microcantilever charged-particle flux detector , 2002 .

[5]  D. Pink,et al.  Thickness and Elasticity of Gram-Negative Murein Sacculi Measured by Atomic Force Microscopy , 1999, Journal of bacteriology.

[6]  Eric Bourillot,et al.  Effects of temperature and pressure on microcantilever resonance response. , 2003, Ultramicroscopy.

[7]  Javier Tamayo,et al.  Effect of the adsorbate stiffness on the resonance response of microcantilever sensors , 2006 .

[8]  Harold G. Craighead,et al.  Virus detection using nanoelectromechanical devices , 2004 .

[9]  H. Craighead,et al.  Attogram detection using nanoelectromechanical oscillators , 2004 .

[10]  Javier Tamayo,et al.  Real-time profile of microcantilevers for sensing applications , 2005 .

[11]  Anja Boisen,et al.  Enhanced functionality of cantilever based mass sensors using higher modes , 2005 .

[12]  James K. Gimzewski,et al.  A femtojoule calorimeter using micromechanical sensors , 1994 .

[13]  Thomas Thundat,et al.  Piezoresistive detection of acoustic waves , 2003 .

[14]  Javier Tamayo,et al.  Origin of the response of nanomechanical resonators to bacteria adsorption , 2006 .

[15]  P. Hansma,et al.  A nondestructive method for determining the spring constant of cantilevers for scanning force microscopy , 1993 .

[16]  A. Boisen,et al.  Temperature and pressure dependence of resonance in multi-layer microcantilevers , 2005 .

[17]  Peter Vettiger,et al.  A chemical sensor based on a micromechanical cantilever array for the identification of gases and vapors , 1998 .

[18]  Jonathan S. Colton,et al.  Influence of surface stress on the resonance behavior of microcantilevers , 2005 .