Design Maximum Power Point Tracking (MPPT) on Photovoltaic Panels using Fuzzy Logic Method

Solar energy is a clean energy, renewable, and available for the long term. The tool used to convert the energy generated from the intensity of sunlight into electricity is photovoltaic panels. However, due to the high cost and low efficiency, the use of the energy is still kind small compared to other types of energy sources. Thus, the need for an effective and flexible models, which resemble the characteristics of the actual photovoltaic (PV), so that we can perform simple manipulation of some data to figure out how to get the maximum performance possible. The characteristic of the solar panel output is specific and non-linear, it depend on the solar irradiation and the temperature of the solar panel. Because of it, it makes us difficult to get the Maximum Power Point (or abbreviated MPP) of the solar panels. Approach: Therefore, to solve these problems required the modeling of the solar panel for design and simulate the algorithms of Maximum Power Point Tracking (MPPT) to maintain the working point of solar panels fixed on the MPP. Overall, the designed system results carried are running well. The increase in the average value of the output voltage by 17%, from an average of 11.6 V before installation into 13.94 V after installation MPPT system. It also occurs in output power with an increase of 28%, from an average of 35.13 W before installing system MPPT into 48.9 W after installation MPPT system. The temperature effect on module voltage and output power before and after installation of the MPPT system that after the installation of the MPPT system, the voltage output of photovoltaic modules can be maintained around the desired maximum value that’s equal to 12 V. But there was a drop in output power value compared to the prior installation MPPT system. This is caused by the output current value that cannot accommodate the value of the output voltage. So that the value of the output current is enough to produce the maximum output power is needed quantities corresponding load.

[1]  Hocine Belmili,et al.  A survey of the most used MPPT methods: Conventional and advanced algorithms applied for photovoltaic systems , 2015 .

[2]  Azami Zaharim,et al.  Optimization of a stand-alone wind/PV hybrid system to provide electricity for a household in Malaysia , 2009 .

[3]  K. Sopian,et al.  Energy and exergy analyses of solar drying system of red seaweed , 2014 .

[4]  K. Sopian,et al.  Performances and improvement potential of solar drying system for palm oil fronds , 2015 .

[5]  M. F. Almi,et al.  Advanced Fuzzy MPPT Controller for a Stand-alone PV System☆ , 2014 .

[6]  Mostafa Mosa,et al.  Modified MPPT with using model predictive control for multilevel boost converter , 2012, IECON 2012 - 38th Annual Conference on IEEE Industrial Electronics Society.

[7]  K. Sopian,et al.  Performance analysis of solar drying system for red chili , 2014 .

[8]  Kamaruzzaman Sopian,et al.  Techno-economic of solar drying systems with water based solar collectors in Malaysia: A review , 2015 .

[9]  K. Sopian,et al.  Performance and cost benefits analysis of double-pass solar collector with and without fins , 2013 .

[10]  Kamaruzzaman Sopian,et al.  Energy analysis and improvement potential of finned double-pass solar collector , 2013 .

[11]  M. Hughes,et al.  Performance Analysis , 2018, Encyclopedia of Algorithms.

[12]  Kamaruzzaman Sopian,et al.  Performance analysis of photovoltaic thermal (PVT) water collectors , 2014 .

[13]  Kamaruzzaman Sopian,et al.  Review of solar dryers for agricultural and marine products , 2010 .

[14]  Kamaruzzaman Sopian,et al.  Review of solar drying systems with air based solar collectors in Malaysia , 2015 .

[15]  S. Nema,et al.  Matlab / simulink based study of photovoltaic cells / modules / array and their experimental verification , 2010 .

[16]  Kamaruzzaman Sopian,et al.  Energy and exergy analysis of hybrid solar drying system , 2016 .

[17]  Kamaruzzaman Sopian,et al.  Efficiencies and improvement potential of building integrated photovoltaic thermal (BIPVT) system , 2014 .

[18]  Kamaruzzaman Sopian,et al.  Performances analysis of greenhouse solar dryer with heat exchanger , 2016 .