Local measurement of geometrically necessary dislocation densities and their strengthening effect in ultra-high deformed pearlite

[1]  J. Sidor,et al.  The dependency of work hardening on dislocation statistics in cold rolled 1050 aluminum alloy , 2022, Materials Characterization.

[2]  N. Hansen,et al.  Microstructure and Strengthening Mechanisms of Nanolamellar Structures in Ultrastrong Drawn Iron Wires , 2021, SSRN Electronic Journal.

[3]  Huajian Gao,et al.  Heterostructured materials: superior properties from hetero-zone interaction , 2020, Materials Research Letters.

[4]  Xiaolei Wu,et al.  Ultrastrong low-carbon nanosteel produced by heterostructure and interstitial mediated warm rolling , 2020, Science Advances.

[5]  Shaohua Chen,et al.  Revealing extra strengthening and strain hardening in heterogeneous two-phase nanostructures , 2020 .

[6]  H. Mughrabi.  Revisiting “Steady-State” Monotonic and Cyclic Deformation: Emphasizing the Quasi-Stationary State of Deformation , 2020, Metallurgical and Materials Transactions A.

[7]  M. François,et al.  Microstructure–Property Relationship in Cold-Drawn Pearlitic Steel Wires , 2020, Metallurgical and Materials Transactions A.

[8]  Xiaolei Wu,et al.  Perspective on hetero-deformation induced (HDI) hardening and back stress , 2019, Materials Research Letters.

[9]  Y. Li,et al.  Ultra-strong and damage tolerant metallic bulk materials: A lesson from nanostructured pearlitic steel wires , 2016, Scientific Reports.

[10]  C. Borchers,et al.  Cold-drawn pearlitic steel wires , 2016 .

[11]  Gholamali Ali Nematollahi,et al.  Deformation‐Induced Martensite: A New Paradigm for Exceptional Steels , 2016, Advanced materials.

[12]  D. Raabe,et al.  Assessment of geometrically necessary dislocation levels derived by 3D EBSD , 2015 .

[13]  M. Herbig,et al.  Combining structural and chemical information at the nanometer scale by correlative transmission electron microscopy and atom probe tomography. , 2015, Ultramicroscopy.

[14]  D. Ponge,et al.  Mechanisms of subgrain coarsening and its effect on the mechanical properties of carbon-supersaturated nanocrystalline hypereutectoid steel , 2015 .

[15]  E. Rauch,et al.  Automated crystal orientation and phase mapping in TEM , 2014 .

[16]  M. Herbig,et al.  Segregation stabilizes nanocrystalline bulk steel with near theoretical strength. , 2014, Physical review letters.

[17]  S. Zaefferer,et al.  Theory and application of electron channelling contrast imaging under controlled diffraction conditions , 2014 .

[18]  M. Herbig,et al.  Atomic-scale quantification of grain boundary segregation in nanocrystalline material. , 2013, Physical review letters.

[19]  N. Hansen,et al.  Hierarchical structures in cold-drawn pearlitic steel wire , 2013 .

[20]  T. Ungár,et al.  Defects in Carbon-Rich Ferrite of Cold-Drawn Pearlitic Steel Wires , 2013, Metallurgical and Materials Transactions A.

[21]  P. Trimby,et al.  Orientation mapping of nanostructured materials using transmission Kikuchi diffraction in the scanning electron microscope. , 2012, Ultramicroscopy.

[22]  D. Raabe,et al.  Evolution of strength and microstructure during annealing of heavily cold-drawn 6.3 GPa hypereutecto , 2012 .

[23]  K. Ushioda,et al.  Quantitative analysis of grain boundaries in carbon- and nitrogen-added ferritic steels by atom probe tomography , 2012 .

[24]  N. Allain-Bonasso,et al.  Quantification of dislocation structure heterogeneity in deformed polycrystals by EBSD , 2012 .

[25]  M. Kamaya.  Assessment of local deformation using EBSD: quantification of accuracy of measurement and definition of local gradient. , 2011, Ultramicroscopy.

[26]  S. Zaefferer.  Orientation microscopy in SEM and TEM: A critical review , 2011 .

[27]  D. Raabe,et al.  Atomic-scale mechanisms of deformation-induced cementite decomposition in pearlite , 2011 .

[28]  D. Raabe,et al.  Atom probe tomography characterization of heavily cold drawn pearlitic steel wire. , 2011, Ultramicroscopy.

[29]  Qing Liu,et al.  Microstructure and strengthening mechanisms in cold-drawn pearlitic steel wire , 2011 .

[30]  G. Eggeler,et al.  On the effect of long-term creep on the microstructure of a 12% chromium tempered martensite ferritic steel , 2009 .

[31]  X. Sauvage,et al.  Complementary use of TEM and APT for the investigation of steels nanostructured by severe plastic deformation , 2009, 0904.2139.

[32]  C. Borchers,et al.  Partially amorphous nanocomposite obtained from heavily deformed pearlitic steel , 2009 .

[33]  T. Tsuchiyama,et al.  Effect of Interstitial Elements on Hall–Petch Coefficient of Ferritic Iron , 2008 .

[34]  Y. Ivanisenko,et al.  The role of carbon segregation on nanocrystallisation of pearlitic steels processed by severe plastic deformation , 2007, 0804.4377.

[35]  H. Mughrabi.  Deformation-induced long-range internal stresses and lattice plane misorientations and the role of geometrically necessary dislocations , 2006 .

[36]  Amit Misra,et al.  Length-scale-dependent deformation mechanisms in incoherent metallic multilayered composites , 2005 .

[37]  T. Furuhara,et al.  Ultra-fine (α+θ) Duplex Structure Formed by Cold Rolling and Annealing of Pearlite , 2005 .

[38]  H. Mughrabi,et al.  On the current understanding of strain gradient plasticity , 2004 .

[39]  V. N. Urtsev,et al.  Dislocation structure of coarse-plate perlite in carbon steel after cold and high-temperature strain , 2004 .

[40]  M. Arai,et al.  Structure analysis of ferrite in deformed pearlitic steel by means of X-ray diffraction method with synchrotron radiation , 2004 .

[41]  N. Hansen,et al.  Microstructural evolution of IF-steel during cold rolling , 2004 .

[42]  W. Fu,et al.  Effect of Mn and Si Addition on Microstructure and Tensile Properties of Cold-rolled and Annealed Pearlite in Eutectoid Fe-C Alloys , 2004 .

[43]  M. Zelin.  Microstructure evolution in pearlitic steels during wire drawing , 2002 .

[44]  J. Weertman,et al.  Anomalous work hardening, non-redundant screw dislocations in a circular bar deformed in torsion, and non-redundant edge dislocations in a bent foil , 2002 .

[45]  T. Furuhara,et al.  Deformation microstructure and tensile strength of cold rolled pearlitic steel sheets , 2000 .

[46]  Y. Bréchet,et al.  Specific dislocation multiplication mechanisms and mechanical properties in nanoscaled multilayers: The example of pearlite , 2000 .

[47]  X. Sauvage,et al.  Atomic-scale observation and modelling of cementite dissolution in heavily deformed pearlitic steels , 2000 .

[48]  Stefan Zaefferer,et al.  New developments of computer-aided crystallographic analysis in transmission electron microscopy , 2000 .

[49]  Huajian Gao,et al.  Mechanism-based strain gradient plasticity— I. Theory , 1999 .

[50]  E. Arzt.  Size effects in materials due to microstructural and dimensional constraints: a comparative review , 1998 .

[51]  X. Sauvage,et al.  Direct evidence of cementite dissolution in drawn pearlitic steels observed by tomographic atom probe , 1998 .

[52]  B. Baudelet,et al.  Evolution of the tensile strength in heavily cold drawn and annealed pearlitic steel wires , 1997 .

[53]  K. Hono,et al.  APFIM and TEM studies of drawn pearlitic wire , 1997 .

[54]  M. Ashby,et al.  Strain gradient plasticity: Theory and experiment , 1994 .

[55]  J. G. Sevillano.  Substructure and strengthening of heavily deformed single and two-phase metallic materials , 1991 .

[56]  William D. Nix,et al.  Mechanical properties of thin films , 1989 .

[57]  G. Langford.  Deformation of pearlite , 1977 .

[58]  V. Gridnev,et al.  Investigation of Carbide Phase in Strained Steel by the Method of Nuclear Gamma Resonance , 1972, December 16, 1972.

[59]  M. Ashby,et al.  Slip in aluminum crystals containing strong, plate-like particles , 1970 .

[60]  M. Ashby.  The deformation of plastically non-homogeneous materials , 1970 .

[61]  J. Embury,et al.  The structure and properties of drawn pearlite , 1966 .

[62]  J. Nye.  Some geometrical relations in dislocated crystals , 1953 .

[63]  E. Hall,et al.  The Deformation and Ageing of Mild Steel: III Discussion of Results , 1951 .

[64]  T. Tsuchiyama,et al.  Effect of Grain Boundary Segregation of Interstitial Elements on Hall–Petch Coefficient in Steels , 2014 .

[65]  J. Takahashi,et al.  Change in carbon state by low-temperature aging in heavily drawn pearlitic steel wires , 2012 .

[66]  Wei Liu,et al.  Evolution of cementite morphology in pearlitic steel wire during wet wire drawing , 2010 .

[67]  Tatsuro Ochi,et al.  Trends in Product Developments of Bars and Wire Rods , 2007 .

[68]  Huajian Gao,et al.  Geometrically necessary dislocation and size-dependent plasticity , 2003 .

[69]  K. Hono,et al.  Atom probe and transmission electron microscopy investigations of heavily drawn pearlitic steel wire , 1999 .

[70]  N. Petch,et al.  The Cleavage Strength of Polycrystals , 1953 .