An energy efficient RF transceiver for wireless microsensor networks

A wireless microsensor network consists of a group of sensor nodes that are deployed remotely and used to relay sensing data to the end-user. Due to their remote deployment, large scale wireless sensor networks require a low-power, energy efficient transceiver that can operate for years on a single battery. Existing wireless transceivers designed for low-power wireless standards like IEEE 802.15.4 have difficulty meeting such stringent energy requirements. Thus, a custom on-off keying wireless transceiver for sensor networks has been designed in a 0.18-μm CMOS process. Power savings are achieved by using an envelope detection based architecture that leverages SAW components and through advanced circuit techniques. The transceiver is power-aware, able to scale power consumption in response to operating conditions. Circuit optimizations are made in both high frequency and baseband circuits to minimize the number of off-chip components and to achieve optimal energy efficiency. A thorough comparison of radio-frequency tuned and untuned gain stages shows that untuned gain can offer energy efficiency advantages in many situations. The transceiver operates in the 900 MHz ISM band at a data rate of 1 Mbps. The receiver’s sensitivity is scalable from -37 dBm to -71 dBm with power consumption ranging from 500 μW to 2.4 mW. These power levels correspond to an energy per bit ratio of 0.5 to 2.4 nanojoules per bit, more than ten times smaller than the ratio of typical wireless receivers. The transmitter supports output power levels from -10 dBm to -1 dBm and has a maximum power efficiency of 11%. Thesis Supervisor: Anantha P. Chandrakasan Title: Professor, Department of Electrical and Computer Engineering

[1]  M. Declercq,et al.  A low-power CMOS super-regenerative receiver at 1 GHz , 2001, IEEE J. Solid State Circuits.

[2]  D.J. Allstot,et al.  A 1.5V 28mA fully-integrated fast-locking quad-band GSM-GPRS transmitter with digital auto-calibration in 130nm CMOS , 2004, 2004 IEEE International Solid-State Circuits Conference (IEEE Cat. No.04CH37519).

[3]  Randy H. Katz,et al.  Next century challenges: mobile networking for “Smart Dust” , 1999, MobiCom.

[4]  T. Melly,et al.  An ultralow-power UHF transceiver integrated in a standard digital CMOS process: transmitter , 2001 .

[5]  A. Chandrakasan,et al.  A micropower programmable DSP powered using a MEMS-based vibration-to-electric energy converter , 2000, 2000 IEEE International Solid-State Circuits Conference. Digest of Technical Papers (Cat. No.00CH37056).

[6]  N. Boom,et al.  A 0.9V 2.2mA multi-channel programmable FM receiver for hearing-aid applications in 0.25 /spl mu/m CMOS , 2004, 2004 IEEE International Solid-State Circuits Conference (IEEE Cat. No.04CH37519).

[7]  A.A. Abidi,et al.  A 4.5-mW 900-MHz CMOS receiver for wireless paging , 2000, IEEE Journal of Solid-State Circuits.

[8]  A.A. Abidi,et al.  RF CMOS comes of age , 2004, 2003 Symposium on VLSI Circuits. Digest of Technical Papers (IEEE Cat. No.03CH37408).

[9]  D. Ruffieux,et al.  A 1.2 mW RDS receiver for portable applications , 2004, IEEE Journal of Solid-State Circuits.

[10]  M. Cloutier,et al.  A 43mW Bluetooth transceiver with -91dBm sensitivity , 2003, 2003 IEEE International Solid-State Circuits Conference, 2003. Digest of Technical Papers. ISSCC..

[11]  D. L. Ash.  SAW-based hybrid transceivers in slam packaging with frequency range from 200 to 1000 MHz , 1998, 1998 IEEE Ultrasonics Symposium. Proceedings (Cat. No. 98CH36102).

[12]  A. Chandrakasan,et al.  A 180mV FFT processor using subthreshold circuit techniques , 2004, 2004 IEEE International Solid-State Circuits Conference (IEEE Cat. No.04CH37519).

[13]  Jan M. Rabaey,et al.  PicoRadio Supports Ad Hoc Ultra-Low Power Wireless Networking , 2000, Computer.

[14]  Ilku Nam,et al.  An experimental coin-sized radio for extremely low-power WPAN (IEEE 802.15.4) application at 2.4 GHz , 2003 .

[15]  Mototsugu Hamada,et al.  A 17-mW 0.66-mm2 direct-conversion receiver for 1-Mb/s cable replacement , 2005 .

[16]  Naveen Verma,et al.  Design considerations for ultra-low energy wireless microsensor nodes , 2005, IEEE Transactions on Computers.

[17]  Mark R. Gehring,et al.  A sequential-gain IC for miniature short-range battery-powered wireless data receivers , 1995, Proceedings ISSCC '95 - International Solid-State Circuits Conference.

[18]  John A. Michon,et al.  Design considerations , 1993, Generic Intelligent Driver Support.

[19]  D. Ruffieux,et al.  A 1 V 433/868 MHz 25 kb/s-FSK 2 kb/s-OOK RF transceiver SoC in standard digital 0.18 /spl mu/m CMOS , 2005, ISSCC. 2005 IEEE International Digest of Technical Papers. Solid-State Circuits Conference, 2005..

[20]  C. Dehollain,et al.  A 2 V, 600 mA, 1 GHz, BiCMOS super-regenerative receiver , 1998, 1998 IEEE International Solid-State Circuits Conference. Digest of Technical Papers, ISSCC. First Edition (Cat. No.98CH36156).

[21]  Jan Crols,et al.  Programmable FM Receiver for Hearing-Aid Applications in 0.25µm CMOS , 2004 .

[22]  Thomas H. Lee,et al.  The Design of CMOS Radio-Frequency Integrated Circuits: RF CIRCUITS THROUGH THE AGES , 2003 .

[23]  Wendi B. Heinzelman,et al.  Application-specific protocol architectures for wireless networks , 2000 .

[24]  R.B. Staszewski,et al.  All-digital phase-domain TX frequency synthesizer for Bluetooth radios in 0.13/spl mu/m CMOS , 2004, 2004 IEEE International Solid-State Circuits Conference (IEEE Cat. No.04CH37519).

[25]  Denis C. Daly,et al.  Energy efficiency of the IEEE 802.15.4 standard in dense wireless microsensor networks: modeling and improvement perspectives , 2005, Design, Automation and Test in Europe.

[26]  SeongHwan Cho,et al.  A 6.5 GHz CMOS FSK modulator for wireless sensor applications , 2002, 2002 Symposium on VLSI Circuits. Digest of Technical Papers (Cat. No.02CH37302).

[27]  K. Muhammad,et al.  A discrete-time Bluetooth receiver in a 0.13/spl mu/m digital CMOS process , 2004, 2004 IEEE International Solid-State Circuits Conference (IEEE Cat. No.04CH37519).

[28]  J.E. Mazo,et al.  Digital communications , 1985, Proceedings of the IEEE.

[29]  Ilku Nam,et al.  An experimental coin-sized radio for extremely low power WPAN (IEEE802.15.4) application at 2.4GHz , 2003, 2003 IEEE International Solid-State Circuits Conference, 2003. Digest of Technical Papers. ISSCC..

[30]  Behzad Razavi,et al.  Design considerations for direct-conversion receivers , 1997 .

[31]  T. Melly,et al.  An ultralow-power UHF transceiver integrated in a standard digital CMOS process: architecture and receiver , 2001 .

[32]  J. Larson,et al.  Ultra-miniature high-Q filters and duplexers using FBAR technology , 2001, 2001 IEEE International Solid-State Circuits Conference. Digest of Technical Papers. ISSCC (Cat. No.01CH37177).

[33]  Lee-Sup Kim,et al.  A 200 MHz 13 mm/sup 2/ 2-D DCT macrocell using sense-amplifying pipeline flip-flop scheme , 1994 .

[34]  Massoud Pedram,et al.  Design considerations for battery-powered electronics , 1999, Proceedings 1999 Design Automation Conference (Cat. No. 99CH36361).

[35]  Chun-Huat Heng,et al.  A 2.4GHz dual-mode 0.18/spl mu/m CMOS transceiver for Bluetooth and 802.11b , 2003, 2003 IEEE International Solid-State Circuits Conference, 2003. Digest of Technical Papers. ISSCC..

[36]  Gabor C. Temes,et al.  Circuit techniques for reducing the effects of op-amp imperfections: autozeroing, correlated double sampling, and chopper stabilization , 1996, Proc. IEEE.