The Impact of Posture and Prolonged Cyclic Compressive Loading on Vertebral Joint Mechanics

Study Design. An in vitro biomechanics investigation exposing porcine functional spinal units (FSUs) to submaximal cyclic or static compressive forces while in a flexed, neutral, or extended posture. Objective. To investigate the combined effect of cyclically applied compressive force (e.g., vibration) and postural deviation on intervertebral joint mechanics. Summary of Background Data. Independently, prolonged vibration exposure and non-neutral postures are known risk factors for development of low back pain and injury. However, there is limited basic scientific evidence to explain how the risk of low back injury from vibration exposure is modified by other mechanical factors. This work examined the influence of static postural deviation on vertebral joint height loss and compressive stiffness under cyclically applied compressive force. Methods. Forty-eight FSUs, consisting of 2 adjacent vertebrae, ligaments, and the intervening intervertebral disc were included in the study. Each specimen was randomized to 1 of 3 experimental posture conditions (neutral, flexed, or extended) and assigned to 1 of 2 loading protocols, consisting of (1) cyclic (1500 ± 1200 N applied at 5 Hz using a sinusoidal waveform, resulting in 0.2 g rms acceleration) or (2) 1500 N of static compressive force. Results. As expected, FSU height loss followed a typical first-order response in both the static and cyclic loading protocols, with the majority (∼50%) of the loss occurring in the first 20 minutes of testing. A significant interaction between posture and loading protocol (P < 0.001) was noted in the magnitude of FSU height loss. Subsequent analysis of simple effects revealed significant differences between cyclic and static loading protocols in both a neutral (P = 0.016) and a flexed posture (P < 0.0001). No significant differences (P = 0.320) were noted between pre/postmeasurements of FSU compressive stiffness. Conclusion. Posture is an important mechanical factor to consider when assessing the risk of injury from cyclic loading to the lumbar spine.

[1]  M. Griffin,et al.  EVALUATION OF WHOLE-BODY VIBRATION IN VEHICLES , 2002 .

[2]  N Dhillon,et al.  The internal mechanics of the intervertebral disc under cyclic loading. , 2002, Journal of biomechanics.

[3]  D G Wilder,et al.  Epidemiological and aetiological aspects of low back pain in vibration environments - an update. , 1996, Clinical biomechanics.

[4]  Diane E. Gregory,et al.  Does Vibration Influence the Initiation of Intervertebral Disc Herniation?: An Examination of Herniation Occurrence Using a Porcine Cervical Disc Model , 2011, Spine.

[5]  S. McGill,et al.  Spinal posture and prior loading history modulate compressive strength and type of failure in the spine: a biomechanical study using a porcine cervical spine model. , 2001, Clinical biomechanics.

[6]  Hendrik Schmidt,et al.  The relation between intervertebral disc bulging and annular fiber associated strains for simple and complex loading. , 2008, Journal of biomechanics.

[7]  B. Winkelstein,et al.  Transient cervical nerve root compression modulates pain: load thresholds for allodynia and sustained changes in spinal neuropeptide expression. , 2008, Journal of biomechanics.

[8]  M. Bovenzi,et al.  An updated review of epidemiologic studies on the relationship between exposure to whole-body vibration and low back pain (1986–1997) , 1999, International archives of occupational and environmental health.

[9]  W C Hutton,et al.  The Effect of Posture on the Fluid Content of Lumbar Intervertebral Discs , 1983, Spine.

[10]  W. Hutton,et al.  Diurnal Variations in the Stresses on the Lumbar Spine , 1987, Spine.

[11]  A. Wright,et al.  Intervertebral Disc Mechanics Are Restored Following Cyclic Loading and Unloaded Recovery , 2004, Annals of Biomedical Engineering.

[12]  P Brinckmann,et al.  Prediction of the compressive strength of human lumbar vertebrae. , 1989, Clinical biomechanics.

[13]  Lutz Claes,et al.  Creep associated changes in intervertebral disc bulging obtained with a laser scanning device. , 2007, Clinical biomechanics.

[14]  Jack P Callaghan,et al.  The role of dynamic flexion in spine injury is altered by increasing dynamic load magnitude. , 2009, Clinical biomechanics.

[15]  S. McGill,et al.  The Effect of Vibration and Posture on the Progression of Intervertebral Disc Herniation , 2011, Spine.

[16]  F. Hartmann,et al.  Biomechanical Properties of Human Intervertebral Discs Subjected to Axial Dynamic Compression: A Comparison of Lumbar and Thoracic Discs , 1984, Spine.

[17]  D G Wilder,et al.  A review of studies on seated whole body vibration and low back pain , 1999, Proceedings of the Institution of Mechanical Engineers. Part H, Journal of engineering in medicine.

[18]  Helmut Seidel,et al.  On the relationship between whole-body vibration exposure and spinal health risk. , 2005, Industrial health.

[19]  J. Callaghan,et al.  Intervertebral neural foramina deformation due to two types of repetitive combined loading. , 2009, Clinical biomechanics.

[20]  J. Ott,et al.  Occupational and Genetic Risk Factors Associated With Intervertebral Disc Disease , 2007, Spine.

[21]  Jaw-Lin Wang,et al.  Rest Cannot Always Recover the Dynamic Properties of Fatigue-Loaded Intervertebral Disc , 2008, Spine.

[22]  W C Hutton,et al.  The effect of posture on the role of the apophysial joints in resisting intervertebral compressive forces. , 1980, The Journal of bone and joint surgery. British volume.

[23]  J. Durkin,et al.  Estimating the Compressive Strength of the Porcine Cervical Spine: An Examination of the Utility of DXA , 2005, Spine.

[24]  M. Bovenzi,et al.  Low back pain disorders and exposure to whole-body vibration in the workplace. , 1996, Seminars in perinatology.

[25]  W. Hutton,et al.  An In Vivo MRI Study of the Changes in Volume (and Fluid Content) of the Lumbar Intervertebral Disc After Overnight Bed Rest and During an 8-Hour Walking Protocol , 2002, Journal of spinal disorders & techniques.

[26]  Rosemary E Thompson,et al.  Defining the Neutral Zone of sheep intervertebral joints during dynamic motions: an in vitro study. , 2003, Clinical biomechanics.

[27]  S. McGill,et al.  Intervertebral disc herniation: studies on a porcine model exposed to highly repetitive flexion/extension motion with compressive force. , 2001, Clinical biomechanics.

[28]  Idsart Kingma,et al.  Contribution of vertebral [corrected] bodies, endplates, and intervertebral discs to the compression creep of spinal motion segments. , 2008, Journal of biomechanics.

[29]  Carel Hulshof,et al.  Whole-body vibration and low-back pain , 1987, International archives of occupational and environmental health.

[30]  I. Stokes,et al.  Different Effects of Static Versus Cyclic Compressive Loading on Rat Intervertebral Disc Height and Water Loss In Vitro , 2007, Spine.