High strength Fe–Mn–(Al, Si) TRIP/TWIP steels development — properties — application

[1]  Hermann Schumann,et al.  Die martensitischen Umwandlungen in kohlenstoffarmen Manganstählen , 1967 .

[2]  K. Ishida,et al.  Effect of Alloying Elements on Stability of Epsilon Iron , 1974 .

[3]  P. F. Parasyuk.  Structure and properties of iron-manganese alloys , 1975 .

[4]  R. E. Schramm,et al.  Stacking fault energies of seven commercial austenitic stainless steels , 1975 .

[5]  L. Meyer,et al.  Dynamic Behavior of High Strength Steels Under Tension , 1981 .

[6]  Werkstoffverhalten hochfester Stähle unter einsinnig dynamischer Belastung , 1982 .

[7]  Siegfried S. Hecker,et al.  Effects of Strain State and Strain Rate on Deformation-Induced Transformation in 304 Stainless Steel: Part I. Magnetic Measurements and Mechanical Behavior , 1982 .

[8]  A. Sato,et al.  Hardening due to pre-existing ϵ-Martensite in an Fe-30Mn-1Si alloy single crystal , 1982 .

[9]  Y. G. Kim,et al.  Low temperature mechanical behavior of microalloyed and controlled-rolled Fe-Mn-Al-C-X alloys , 1985 .

[10]  Y. Tomota,et al.  Microstructural dependence of Fe-high Mn tensile behavior , 1986 .

[11]  L. Meyer,et al.  Impact loading and dynamic behaviour of materials , 1988 .

[12]  Y. G. Kim,et al.  Composition and temperature dependence of tensile properties of austenitic FeMnAlC alloys , 1989 .

[13]  Kazunori Sato,et al.  Effects of Deformation Induced Phase Transformation and Twinning on the Mechanical Properties of Austenitic Fe–Mn–Al Alloys , 1989 .

[14]  U. S. Lindholm,et al.  Shock Wave and High-Strain-Rate Phenomena in Materials , 1992 .

[15]  L. Meyer,et al.  Adiabatic shear failure under biaxial dynamic compression/ shear loading , 1994 .

[16]  S. Nemat-Nasser,et al.  Experimental/ computational evaluation of flow stress at high strain rates with application to adiabatic shear banding , 1994 .

[17]  A. F. Guillermet,et al.  Fcc/Hcp martensitic transformation in the Fe-Mn system: Experimental study and thermodynamic analysis of phase stability , 1995 .

[18]  The effects of deformation twins and strain-induced ϵ-martensite on mechanical properties of an Fe-32Mn-12Cr-0.4C cryogenic alloy , 1995 .

[19]  Yoshihiro Tomita,et al.  Constitutive modeling of TRIP steel and its application to the improvement of mechanical properties , 1995 .

[20]  K. T. Ramesh,et al.  A technique for measuring the dynamic behavior of materials at high temperatures , 1998 .

[21]  Akhtar S. Khan,et al.  Behaviors of three BCC metal over a wide range of strain rates and temperatures: experiments and modeling , 1999 .