Phasic icing phenomena of part single cells during the successful cold start processes of PEMFC stacks

[1]  Qi Zhang,et al.  Enhanced operational performance of PEM fuel cells with Porous-Carbon catalyst support: A multiscale modeling approach , 2023, Energy Conversion and Management.

[2]  Fei Wang,et al.  Experimental study on rapid cold start-up performance of PEMFC system , 2023, International Journal of Hydrogen Energy.

[3]  Z. Shao,et al.  Study on Internal Dynamic Response During Cold Start of Proton Exchange Membrane Fuel Cell with Parallel and Serpentine Flow Fields , 2023, Social Science Research Network.

[4]  T. Jahnke,et al.  Assisted cold start of a PEMFC with a thermochemical preheater: A numerical study , 2023, Applied Energy.

[5]  Siyuan Wu,et al.  Investigation of assisted heating cold start strategies from -40 °C for proton exchange membrane fuel cell stack , 2023, International Journal of Green Energy.

[6]  F. Jiang,et al.  Influence of cathode channel blockages on the cold start performance of proton exchange membrane fuel cell: A numerical study , 2023, Energy.

[7]  F. Harel,et al.  A new cooling circuit and its control strategies for the thermal management of PEMFC in rapid startup application , 2023, International Journal of Hydrogen Energy.

[8]  K. Min,et al.  Analysis of performance degradation on the components in polymer electrolyte membrane fuel cell by dissecting the oxygen diffusion region , 2022, Journal of Power Sources.

[9]  Mingzhang Pan,et al.  Maximum power tracking-based adaptive cold start strategy for proton exchange membrane fuel cell , 2022, Energy Conversion and Management.

[10]  Shixue Wang,et al.  Performance of proton exchange membrane fuel cells with microporous layer hydrophobized by polyphenylene sulfide at conventional temperature and cold start , 2022, International Journal of Hydrogen Energy.

[11]  P. He,et al.  Numerical Research on the Cold Start-up Strategy of a PEMFC Stack from −30°C , 2022, Journal of Thermal Science.

[12]  Linjun Li,et al.  Cold start optimization of the proton-exchange membrane fuel cell by penetrating holes in the cathode micro-diffusion layer , 2022, International Journal of Hydrogen Energy.

[13]  Z. Shao,et al.  An Efficient Cold Start Strategy for Proton Exchange Membrane Fuel Cell Stacks , 2022, SSRN Electronic Journal.

[14]  Jiang Xiaohui,et al.  Characteristics of proton exchange membrane fuel cell considering “dot matrix” gas distribution zones and waveform staggered flow field with cooling channels , 2022, Energy Conversion and Management.

[15]  Z. Zhan,et al.  Two-Dimensional Simulation of the Freezing Characteristics in PEMFCs during Cold Start Considering Ice Crystallization Kinetics , 2022, Polymers.

[16]  Z. Zhan,et al.  End Plate Effects on the Performance of PEMFCs During Cold Start Process , 2021, Journal of The Electrochemical Society.

[17]  Huicui Chen,et al.  Effects of temperature on the performance of fuel cell hybrid electric vehicles: A review , 2021 .

[18]  Jun Zhang,et al.  Cold start investigation of fuel cell vehicles with coolant preheating strategy , 2021, Applied Thermal Engineering.

[19]  Z. Shao,et al.  Study on the temperature distribution and its effect on self-start of large-area proton exchange membrane fuel cells at subzero temperatures , 2021, Electrochimica Acta.

[20]  R. Lin,et al.  Experimental validation for enhancement of PEMFC cold start performance: Based on the optimization of micro porous layer , 2021 .

[21]  N. Brandon,et al.  Designing the next generation of proton-exchange membrane fuel cells , 2021, Nature.

[22]  K. Jiao,et al.  Numerical investigations of assisted heating cold start strategies for proton exchange membrane fuel cell systems , 2021 .

[23]  F. Jiang,et al.  Effects of Endplate Assembly on Cold Start Performance of Proton Exchange Membrane Fuel Cell Stacks , 2021 .

[24]  S. Kelouwani,et al.  An Online Self Cold Startup Methodology for PEM Fuel Cells in Vehicular Applications , 2020, IEEE Transactions on Vehicular Technology.

[25]  J. Kallo,et al.  Efficient thermal management strategies for cold starts of a proton exchange membrane fuel cell system , 2020 .

[26]  Xianguo Li,et al.  Degradations in the surface wettability and gas permeability characteristics of proton exchange membrane fuel cell electrodes under freeze-thaw cycles: Effects of ionomer type , 2020 .

[27]  Yun Wang,et al.  Three-dimensional simulation of a new cooling strategy for proton exchange membrane fuel cell stack using a non-isothermal multiphase model , 2019, Applied Energy.

[28]  P. Sui,et al.  Flow sharing and turbulence phenomena in proton exchange membrane fuel cell stack headers , 2019, International Journal of Hydrogen Energy.

[29]  M. Ni,et al.  Consistency analysis of polymer electrolyte membrane fuel cell stack during cold start , 2019, Applied Energy.

[30]  Ned Djilali,et al.  Experimental study on different preheating methods for the cold-start of PEMFC stacks , 2018, Energy.

[31]  P. Sui,et al.  Numerical analysis of ice-induced stresses in the membrane electrode assembly of a PEM fuel cell under sub-freezing operating conditions , 2018 .

[32]  P. Pei,et al.  Novel approach to determine cathode two-phase-flow pressure drop of proton exchange membrane fuel cell and its application on water management , 2017 .

[33]  Sousso Kelouwani,et al.  A Comprehensive Review of Solutions and Strategies for Cold Start of Automotive Proton Exchange Membrane Fuel Cells , 2016, IEEE Access.

[34]  K. Tajiri,et al.  Current density and ohmic resistance distribution in the land-channel direction of a proton exchange membrane fuel cell , 2015 .

[35]  Qing Du,et al.  Catalytic hydrogen–oxygen reaction in anode and cathode for cold start of proton exchange membrane fuel cell , 2015 .

[36]  Kui Jiao,et al.  Elucidating the constant power, current and voltage cold start modes of proton exchange membrane fuel cell , 2014 .

[37]  Kui Jiao,et al.  Modeling of cold start processes and performance optimization for proton exchange membrane fuel cell stacks , 2014 .

[38]  Y. Takagi,et al.  Decay of material properties of degraded MEA caused by repeated cold starts under subzero conditions in polymer electrolyte fuel cells , 2013 .

[39]  M. Kim,et al.  Phase-change-related degradation of catalyst layers in proton-exchange-membrane fuel cells , 2013 .

[40]  Qing Du,et al.  Analysis of cold start processes in proton exchange membrane fuel cell stacks , 2013 .

[41]  Hyunchul Ju,et al.  Evaluating cold-start behaviors of end and intermediate cells in a polymer electrolyte fuel cell (PEFC) stack , 2012 .

[42]  Xianguo Li,et al.  Degradation of gas diffusion layers through repetitive freezing , 2011 .

[43]  Hee-Tak Kim,et al.  Effect of air purging and dry operation on durability of PEMFC under freeze/thaw cycles , 2011 .

[44]  Young-Jun Sohn,et al.  Investigation of freeze/thaw durability in polymer electrolyte fuel cells , 2010 .

[45]  Wei Liu,et al.  Degradation behaviors of polymer electrolyte membrane fuel cell under freeze/thaw cycles , 2010 .

[46]  Xianguo Li,et al.  Effects of various operating and initial conditions on cold start performance of polymer electrolyte membrane fuel cells , 2009 .

[47]  Dietmar Gerteisen,et al.  Degradation effects in polymer electrolyte membrane fuel cell stacks by sub-zero operation : An in situ and ex situ analysis , 2008 .

[48]  Chao-Yang Wang,et al.  Potentiostatic Start-Up of PEMFCs from Subzero Temperatures , 2008 .

[49]  Manish Khandelwal,et al.  One-dimensional thermal model of cold-start in a polymer electrolyte fuel cell stack , 2007 .

[50]  Chao-Yang Wang,et al.  Effects of operating and design parameters on PEFC cold start , 2007 .

[51]  Chao-Yang Wang,et al.  Isothermal Cold Start of Polymer Electrolyte Fuel Cells , 2007 .

[52]  Hongwei Wang,et al.  Analysis of PEMFC freeze degradation at −20 °C after gas purging , 2006 .

[53]  Hossein Toghiani,et al.  Effect of sub-freezing temperatures on a PEM fuel cell performance, startup and fuel cell components , 2006 .

[54]  R. M. Moore,et al.  Polymer electrolyte fuel cell stack thermal model to evaluate sub-freezing startup , 2005 .

[55]  Kui Jiao,et al.  Cold start of proton exchange membrane fuel cell , 2018 .

[56]  Thomas J. Dursch,et al.  Ice-Crystallization Kinetics in the Catalyst Layer of a Proton-Exchange-Membrane Fuel Cell , 2014 .

[57]  C. Spiegel.  Chapter 6 – Heat Transfer , 2008 .