Three dimensional numerical simulation and analysis of the airside performance of slotted fin surfaces with radial strips

Purpose – To provide some heat transfer and friction factor results for fin‐and‐tube heat transfer surfaces which may be used in air conditioning industry.Design/methodology/approach – Numerical simulation approach was adopted to compare the plain plate fin and three types of radial slotted fin surfaces.Findings – It is found that at the same frontal velocity (1.0‐3 m/s) the plain plate fin has the lowest heat transfer rate with the smallest pressure drop. The full slotted fin surface has the highest heat transfer rate with the largest pressure drop penalty. The partially slotted fin (where the strips are mainly located in the rear part of the fin) and the back slotted fin are some what in between. Under the identical pumping power constraint, the partially slotted fin surface behaves the best.Research limitations/implications – The results are only valid the two‐row fin surface.Practical implications – The results are very useful for the design of two‐row tube fin surfaces with high efficiency.Originalit...

[1]  G. Croce,et al.  CONVECTIVE HEAT AND MASS TRANSFER IN TUBE-FIN EXCHANGERS UNDER DEHUMIDIFYING CONDITIONS , 2001 .

[2]  Wen-Quan Tao,et al.  Field synergy principle for enhancing convective heat transfer--its extension and numerical verifications , 2002 .

[3]  Morgan Heikal,et al.  Progress in the numerical analysis of compact heat exchanger surfaces , 2001 .

[4]  Wei Li,et al.  Experimental study on heat transfer and pressure drop characteristics of four types of plate fin-and-tube heat exchanger surfaces , 1994 .

[5]  Chi-Chuan Wang,et al.  A comparative study of compact enhanced fin-and-tube heat exchangers , 2001 .

[6]  Hiroyuki Ozoe, Wen-Quan Tao.  A Modified Pressure-Correction Scheme for the SIMPLER Method, MSIMPLER , 2001 .

[7]  Wen-Quan Tao,et al.  An experimental study on heat/mass transfer and pressure drop characteristics for arrays of nonuniform plate length positioned obliquely to the flow direction , 1993 .

[8]  S. Wang,et al.  Novel Concept and Device of Heat Transfer Augmentation , 1998 .

[9]  Chi-Chuan Wang,et al.  A numerical investigation of louvered fin-and-tube heat exchangers having circular and oval tube configurations , 2001 .

[10]  D. P. Sekulic,et al.  Fundamentals of Heat Exchanger Design , 2003 .

[11]  Chia-Jung Hsu.  Numerical Heat Transfer and Fluid Flow , 1981 .

[12]  Chi-Chang Wang,et al.  Transient force and free convection along a vertical wavy surface in micropolar fluids , 2001 .

[13]  R. Webb.  Principles of Enhanced Heat Transfer , 1994 .

[14]  Morgan Heikal,et al.  Two- and three-dimensional numerical models of flow and heat transfer over louvred fin arrays in compact heat exchangers , 1998 .

[15]  Wei Zhang,et al.  Three-dimensional numerical study of heat transfer characteristics of plain plate fin-and-tube heat exchangers from view point of field synergy principle , 2005 .

[16]  Wen-Quan Tao,et al.  A unified analysis on enhancing single phase convective heat transfer with field synergy principle , 2002 .

[17]  Bu-Xuan Wang,et al.  A novel concept for convective heat transfer enhancement , 1998 .

[18]  A. London,et al.  Compact heat exchangers , 1960 .

[19]  Ralph L. Webb,et al.  Numerical predictions of wavy fin coil performance , 2001 .