Ion current measurement for parameter estimation in small two stroke engines

Reduction of unburned hydrocarbon emissions and fuel economy improvements in two stroke engines, used on small portable tools for gardening or agriculture, rely on good insights into the combustion process and the engine operating parameters. Meaningful information about the engine operating parameters can be retrieved from ion current measurements. This article demonstrates an approach for monitoring the combustion process in two stroke engines by measuring the ion concentration during internal combustion. Especially the estimation of the air-fuel ratio (AFR) and the detection of misfire are made possible by this measurement concept. Due to lack of sensor placement space in these small engines the use of the conventional spark plug is advantageous. The results obtained by the ion measurement concept show that the optimization of the combustion process can be developed through simple means.

[1]  Yuichi Shimasaki,et al.  Spark plug voltage analysis for monitoring combustion in an internal combustion engine , 1993 .

[2]  Fabian Mauss,et al.  Local Air-Fuel Ratio Measurements Using the Spark Plug as an Ionization Sensor , 1997 .

[3]  Pascal Higelin,et al.  Limitations of Ionization Current Sensors and Comparison with Cylinder Pressure Sensors , 2000 .

[4]  T. M. Sugden,et al.  Mass spectrometry of the ions present in hydrocarbon flames , 1958 .

[5]  Bengt Johansson,et al.  The Effect of In-Cylinder Gas Flow on the Interpretation of the Ionization Sensor Signal , 2003 .

[6]  Ingemar Andersson.  A Comparison of Combustion Temperature Models for Ionization Current Modeling in an SI Engine , 2004 .

[7]  Lars Nielsen,et al.  Ionization current interpretation for ignition control in internal combustion engines , 1996 .

[8]  Gordon P. Blair,et al.  The Basic Design of Two Stroke Engines , 1990 .

[9]  H. F. Calcote.  Ion production and recombination in flames , 1961 .

[10]  T. Weißgerber,et al.  Spark Control for Ion Current Sensing , 2016 .

[11]  Petter Strandh,et al.  Fuel and Additive Influence on the Ion Current , 1998 .

[12]  Ahmed A. Abdel-Rehim,et al.  Characteristics of ion current signals in compression ignition and spark ignition engines , 2010 .

[13]  Eiji Tomita,et al.  Fundamental study on combustion diagnostics using a spark plug as ion probe , 2000 .

[14]  Fabian Mauss,et al.  IN-CYLINDER PRESSURE MEASUREMENTS USING THE SPARK PLUG AS AN IONIZATION SENSOR , 1997 .

[15]  Ahmed A. Abdel-Rehim,et al.  Impact of A/F Ratio on Ion Current Features Using Spark Plug with Negative Polarity , 2008 .

[16]  Raymond Reinmann,et al.  An Ionization Equilibrium Analysis of the Spark Plug as an Ionization Sensor , 1996 .

[17]  Kai W. Beck,et al.  Ion-Current Measurement in Small Two-Stroke SI Engines , 2008 .

[18]  Dario Catanese,et al.  Use of Ionization Current to Estimate CO Rate in a Small 2-Stroke SI Engine , 2015 .