Current-Reuse Transformer-Coupled Oscillators With Output Power Combining for Galvanically Isolated Power Transfer Systems

This paper presents a galvanically isolated power transfer system based on two inductively coupled CMOS oscillators with on-chip isolation transformer. The oscillators share the same current and are loaded by an integrated transformer that performs the combining of the oscillation signals at its secondary winding output. By using a thick inter-metal oxide layer for the integrated transformer, a galvanic isolation rating as high as 5 kV is guaranteed. Thanks to the proposed circuit topology, a 300-mW dc-ac power conversion performance with an excellent 36.5% power efficiency was achieved in a 0.8- μm CMOS technology at 5-V power supply. A complete dc-dc converter was also demonstrated by including a rectifier on a second die. An output power of 200 mW at 8-V output voltage with power efficiency better than 27% was measured.

[1]  T. Biondi,et al.  Analysis and modeling of layout scaling in silicon integrated stacked transformers , 2006, IEEE Transactions on Microwave Theory and Techniques.

[2]  S. S. Mohan,et al.  The design, modeling and optimization of on-chip inductor and transformer circuits , 1999 .

[3]  Egidio Ragonese,et al.  Characterization and modeling of silicon integrated spiral inductors for high-frequency applications , 2007 .

[4]  Egidio Ragonese,et al.  Design methodology for the optimization of transformer-loaded RF circuits , 2006, 2005 IEEE International Symposium on Circuits and Systems.

[5]  W. R. Eisenstadt,et al.  High-speed VLSI interconnect modeling based on S-parameter measurements , 1993 .

[6]  Pietro Andreani,et al.  Class-D CMOS Oscillators , 2013, IEEE Journal of Solid-State Circuits.

[7]  C.J.M. Verhoeven,et al.  Synchronization of two LC-oscillators using nonlinear models , 2007, 2007 50th Midwest Symposium on Circuits and Systems.

[8]  R. Kliger,et al.  Integrated transformer-coupled isolation , 2003, IEEE Instrumentation & Measurement Magazine.

[9]  Luís Bica Oliveira,et al.  Synchronization of two LC- oscillators using capacitive coupling , 2008, 2008 IEEE International Symposium on Circuits and Systems.

[10]  Egidio Ragonese,et al.  Scalable lumped modeling of single-ended and differential inductors for RF IC design , 2009 .

[11]  Stephen P. Boyd,et al.  Simple accurate expressions for planar spiral inductances , 1999, IEEE J. Solid State Circuits.

[12]  Tadashi Maeda,et al.  A 2.5 kV Isolation 35 kV/us CMR 250 Mbps Digital Isolator in Standard CMOS With a Small Transformer Driving Technique , 2012, IEEE Journal of Solid-State Circuits.

[13]  N. M. Ibrahim,et al.  Analysis of current crowding effects in multiturn spiral inductors , 2001 .

[14]  Baoxing Chen,et al.  Fully integrated isolated dc-dc converter using micro-transformers , 2008, 2008 Twenty-Third Annual IEEE Applied Power Electronics Conference and Exposition.

[15]  N. Sooch,et al.  A CMOS direct access arrangement using digital capacitive isolation , 2001, 2001 IEEE International Solid-State Circuits Conference. Digest of Technical Papers. ISSCC (Cat. No.01CH37177).

[16]  Baoxing Chen,et al.  Isolated half-bridge gate driver with integrated high-side supply , 2008, 2008 IEEE Power Electronics Specialists Conference.

[17]  A. Scuderi,et al.  Integrated Inductors and Transformers: Characterization, Design and Modeling for RF and MM-Wave Applications , 2010 .

[18]  Egidio Ragonese,et al.  A lumped scalable model for silicon integrated spiral inductors , 2004, IEEE Transactions on Circuits and Systems I: Regular Papers.

[19]  M. Stecher,et al.  Key technologies for system-integration in the automotive and Industrial Applications , 2005, IEEE Transactions on Power Electronics.