Flow-induced vibration of nuclear steam generator U-tubes in two-phase flow

Flow-induced vibration characteristics of a U-tube bundle were experimentally investigated in air–water two-phase flow. The test section was equipped with 39 U-tubes, simulating the innermost region of an actual steam generator. The U-tubes were made of Inconel 690 with a diameter of 19.05 mm. The horizontal region of the U-tubes had a rotated square array with a pitch of 31.11 mm and a p/d of 1.633. The U-tubes and supporting structures have almost the same prototypical geometries. Vibration responses of six U-tubes were measured with ten 3-axis accelerometers. Two sets of experiments were performed to investigate an onset of fluid-elastic instability, damping ratio, and hydrodynamic mass of the U-tubes. The experiments were performed for a void fraction of 70–95%. The instability constant (K) of the Connors’ equation for the present U-tube bundle was evaluated to be in the range of 6.5–10.5.

[1]  David S. Weaver,et al.  Vortex shedding and fluidelastic instability in a normal square tube array excited by two-phase cross-flow , 2003 .

[2]  Mk Au-Yang,et al.  Flow-Induced Vibration of Power and Process Plant Components: A Practical Workbook , 2001 .

[3]  M. J. Pettigrew,et al.  The Effects of Bundle Geometry on Heat Exchanger Tube Vibration in Two-Phase Cross Flow , 2001 .

[4]  Njuki W. Mureithi,et al.  Dynamics of an in-line tube array subjected to steam-water cross-flow. Part III: Fluidelastic instability tests and comparison with theory , 2002 .

[5]  M. J. Pettigrew,et al.  Vibration behavior of rotated triangular tube bundles in two-phase cross flows , 2002 .

[6]  L. N. Carlucci,et al.  Experimental studies of damping and hydrodynamic mass of a cylinder in confined two-phase flow. [Nuclear reactor cooling system] , 1981 .

[7]  Heung June Chung,et al.  FLUID-ELASTIC INSTABILITY OF ROTATED SQUARE TUBE ARRAY IN AN AIR-WATER TWO-PHASE CROSSFLOW , 2006 .

[8]  M. J. Pettigrew,et al.  Vibration damping of heat exchangertubes in liquids: Effects of support parameters , 1988 .

[9]  H. J. Connors.  Fluidelastic Vibration of Tube Arrays Excited by Cross Flow , 1970 .

[10]  Njuki W. Mureithi,et al.  DYNAMICS OF AN IN-LINE TUBE ARRAY SUBJECTED TO STEAM–WATER CROSS-FLOW. PART I: TWO-PHASE DAMPING AND ADDED MASS , 2002 .

[11]  K. H. Haslinger,et al.  Vibration Response of a U-Tube Bundle with Anti-Vibration Bar Supports due to Turbulence and Fluidelastic Excitations , 1995 .

[12]  M. J. Pettigrew,et al.  Vibration of Tube Bundles in Two-Phase Cross-Flow: Part 2—Fluid-Elastic Instability , 1989 .

[13]  David S. Weaver,et al.  Fluidelastic Instability in a Tube Array Subjected to Two-Phase R-11 Cross-Flow , 1995 .

[14]  Heung June Chung,et al.  Fluid-Elastic Instability of Rotated Square Array U-Tubes in Air-Water Flow , 2009 .

[15]  B. Villard,et al.  Flow-induced vibration of steam generator tubes. Final report , 1986 .

[16]  I. G. Currie,et al.  Vibration of a Tube Bundle in Two-Phase Freon Cross-Flow , 1995 .

[17]  M. J. Pettigrew,et al.  Vibration of Tube Bundles in Two-Phase Cross-Flow: Part 1—Hydrodynamic Mass and Damping , 1989 .

[18]  M. J. Pettigrew,et al.  Fluidelastic Instability and Work-Rate Measurements of Steam-Generator U-Tubes in Air–Water Cross-Flow , 2005 .