Experimental characterisation and constitutive modelling of RTM-6 resin under impact loading

Abstract The response to mechanical loading of the thermosetting resin system RTM-6 has been investigated experimentally as a function of strain rate and a constitutive model has been applied to describe the observed and quantified material behaviour. In order to determine strain rate effects and to draw conclusions about the hydrostatic stress dependency of the material, specimens were tested in compression and tension at strain rates from 10−3 to 104 s−1. A Standard screw-driven tensile machine was used for quasi-static testing, with an ‘in house’ hydraulic rig and Hopkinson bars for medium and high strain rates, respectively. At all rates appropriate photography and optical metrology have been used for direct strain measurement, observation of failure and validation of experimental procedures. In order to enable the experimental characterisation of this brittle material at very high rates in tension, a novel pulse shaping technique has been applied. With the help of this device, strain rates of up to 3800 s−1 have been achieved while maintaining homogeneous deformation state until specimen fracture in the gauge section of the tensile specimens. The yield stress and initial modulus increased with increasing strain rate for both compression and tension, while the strain to failure decreased with strain rate in tension. An existing constitutive model, the Goldberg model has been extended in order to take into account the nonlinear strain rate dependence of the elastic modulus. The model has been validated against 3-point impact bending tests of prismatic RTM-6 beams.