When a beam of light is incident on a translucent sample, a significant fraction of the light is scattered at high angles. Some of this scattered light may be trapped inside the substrate through multiple reflections and total internal reflection, similar to light coupling into an optical fiber. The trapping depends on factors such as the surface roughness of the external surfaces and/or the size and distribution of scattering particles inside the sample. The scattered light may thus escape out of the sample at a shifted position relative to the incident beam. This leads to port losses in an integrating sphere. The detected signal from the light entering the sphere then underestimates the hemispherical transmittance. In this paper the signal versus lateral position has been measured in an attempt to estimate the error and to find an extrapolation procedure for the correct transmittance value. The lateral measurements were carried out by moving a detector behind the sample, a procedure carried out at several angles of incidence. Different illumination methods have also been studied both theoretically and experimentally to further investigate what effect light trapping can have when characterising scattering samples.
[1]
Arne Roos,et al.
Use of an integrating sphere in solar energy research
,
1993
.
[2]
A. Roos,et al.
Interpretation of integrating sphere signal output for nonideal transmitting samples.
,
1991,
Applied optics.
[3]
Werner Platzer.
Solar transmission of transparent insulation material
,
1987
.
[4]
A. Roos,et al.
Evaluation of correction factors for transmittance measurements in single-beam integrating spheres.
,
1994,
Applied optics.
[5]
F. Clarke,et al.
Correction Methods for Integrating Sphere Measurement of Hemispherical Reflectance
,
1987
.
[6]
K. Hollands,et al.
Solar transmittance measurements using an integrating sphere with broad area irradiation
,
1994
.
[7]
W. Platzer.
Directional-hemispherical solar transmittance data for plastic honeycomb-type structures
,
1992
.