Predicting a Material's Machining Characteristics Using Flow Stress Properties Obtained from High-Speed Compression Tests

A theory is given for calculating chip geometry, cutting forces, etc., from fundamental work material properties and cutting conditions. The flow stress properties of the work material (0·16 per cent carbon steel) used in the analysis are taken from high-speed compression test results. The theory predicts the main trends observed in machining experiments and a limited comparison with experimental results shows good quantitative agreement. A possible explanation for the occurrence of a built-up edge, involving the dynamic strain ageing (blue-brittleness) of the chip along the tool-chip interface, is considered and found to be consistent with the results.