论文信息 - PEM FC Single Cell Based on a 3-D Printed Plastic Housing and Experimental Validation with the Mathematical Model

PEM FC Single Cell Based on a 3-D Printed Plastic Housing and Experimental Validation with the Mathematical Model

Abstract This paper presents the design, modelling, and testing of a PEM single fuel cell based on the use of 3D printing. The design of the housings was made of SolidWorks, while MATLAB/SIMULINK were used to model performance. The fabricated cell performed satisfactorily with no leaks of gas, showing that the 3D printing method can be used in the additive manufacturing of fuel cells thus leading to significant cost savings.

Mohan Kolhe | Mohamed J. M. A. Rasul | Y. Sanath K. De Silva | Peter Hugh Middleton

[1] Arunkumar Jayakumar,et al. Manufacturing the Gas Diffusion Layer for PEM Fuel Cell Using a Novel 3D Printing Technique and Critical Assessment of the Challenges Encountered , 2017, Materials.

[2] Viral S. Mehta,et al. Review and analysis of PEM fuel cell design and manufacturing , 2003 .

[3] Abdellah Beicha,et al. Modeling and simulation of proton exchange membrane fuel cell systems , 2012 .

[4] K. Agbossou,et al. PEM Fuel Cells Modeling and Analysis Through Current and Voltage Transient Behaviors , 2008, IEEE Transactions on Energy Conversion.

[5] M.H. Nehrir,et al. Dynamic models and model validation for PEM fuel cells using electrical circuits , 2005, IEEE Transactions on Energy Conversion.