Influence of pore-size distribution of diffusion layer on mass-transport problems of proton exchange membrane fuel cells

The influence of pore-size distribution of the diffusion layer on mass-transport problems of proton exchange membrane fuel cells (PEMFCs) is investigated using electrodes with hydrophobic diffusion layers for which the pore-size distribution is designed by pore-former and heat treatment. It is confirmed that the pore-size distribution of the diffusion layer is a more critical parameter for mass-transport processes within the electrode and for cell performance characteristics than the total porosity itself. Data obtained from mercury intrusion porosimetry, single-cell performance tests and ac impedance analyses indicate that the performance loss due to mass-transport limitations can be reduced by enlarging the macropore volume in the diffusion layer. The water flooding problem is discussed in terms of condensation phenomena which are dependent on pore-size.

[1]  D. Wilkinson,et al.  Anode water removal: A water management and diagnostic technique for solid polymer fuel cells , 1995 .

[2]  J. Jindra,et al.  Porosity and catalyst utilization of thin layer cathodes in air operated PEM-fuel cells , 1998 .

[3]  A. Shukla,et al.  Diffusion layer parameters influencing optimal fuel cell performance , 2000 .

[4]  Supramaniam Srinivasan,et al.  Analysis of performance and of water and thermal management in proton exchange membrane fuel cells , 1995 .

[5]  Yong Woo Rho,et al.  Mass Transport Phenomena in Proton Exchange Membrane Fuel Cells Using O 2 / He , O 2 / Ar , and O 2 / N 2 Mixtures I . Experimental Analysis , 1994 .

[6]  G. Squadrito,et al.  Effects of the Diffusion Layer Characteristics on the Performance of Polymer Electrolyte Fuel Cell Electrodes , 2001 .

[7]  Jingrong Yu,et al.  Investigation of platinum utilization and morphology in catalyst layer of polymer electrolyte fuel cells , 1999 .

[8]  T. Nguyen,et al.  Effect of direct liquid water injection and interdigitated flow field on the performance of proton exchange membrane fuel cells , 1998 .

[9]  E. Passalacqua,et al.  Influence of the PTFE content in the diffusion layer of low-Pt loading electrodes for polymer electrolyte fuel cells , 1998 .

[10]  Mark W. Verbrugge,et al.  A Mathematical Model of the Solid‐Polymer‐Electrolyte Fuel Cell , 1992 .

[11]  T. Springer,et al.  Characterization of polymer electrolyte fuel cells using ac impedance spectroscopy , 1996 .

[12]  Shimshon Gottesfeld,et al.  Low platinum loading electrodes for polymer electrolyte fuel cells fabricated using thermoplastic ionomers , 1995 .

[13]  Edson A. Ticianelli,et al.  Development and electrochemical studies of gas diffusion electrodes for polymer electrolyte fuel cells , 1996 .

[14]  K. Oguro,et al.  Simulation of a polymer electrolyte fuel cell electrode , 1997 .