Ultra-wideband radar sensors for short-range vehicular applications

The recent approval granted by the Federal Communications Commission (FCC) for the use of ultra-wideband signals for vehicular radar applications has provided a gateway for the introduction of these sensors in the commercial arena as early as 2004. However, the rules governing the allowable spectral occupancy create significant constraints on the sensors' operation. This is further complicated by the variety of applications that these sensors are being required to fulfill. A review of the motivation for the development of these sensors is followed by a discussion of the consequent implications for waveform design and limitations on system architecture. Other practical considerations such as available semiconductor technology, packaging, and assembly techniques are reviewed, and results are presented for conventional surface-mount plastic packages illustrating their usefulness in the greater than 20-GHz frequency range. Suitable antenna technology for wide-band transmission is presented that is compliant with the specific restrictions stipulated in the FCC ruling. Finally, all of these considerations are combined with the presentation of a compatible integrated-circuit-based transceiver architecture. Measured results are presented for several critical circuit components including a +12-dBm driver amplifier for the transmitter, an RF pulse generator that can produce sub-1-ns pulses at a carrier frequency of 24 GHz, and a single-chip homodyne in-phase/quadrature down-conversion receiver that has a cascaded noise figure of less than 7 dB. All circuit components are fabricated in SiGe.

[1]  David Shively.  Ultra-wideband radio: The new part 15 , 2003 .

[2]  Holger H. Meinel.  Automotive Millimeterwave Radar History and present Status , 1998, 1998 28th European Microwave Conference.

[3]  Rodger E. Ziemer,et al.  Principles of communications : systems, modulation, and noise , 1985 .

[4]  D. Pozar.  Microstrip antenna aperture-coupled to a microstripline , 1985 .

[5]  R. Weigel,et al.  Single-Chip 19 and 24-GHz VCO and Frequency Divider Fabricated in a Commercial SiGe Bipolar Technology , 2002, 2002 32nd European Microwave Conference.

[6]  B. Jagannathan,et al.  40 Gbit/sec circuits built from a 120 GHz f/sub T/ SiGe technology , 2001, GaAs IC Symposium. IEEE Gallium Arsenide Integrated Circuit Symposium. 23rd Annual Technical Digest 2001 (Cat. No.01CH37191).

[7]  I. Gresham,et al.  A low-noise broadband SiGe mixer for 24GHz ultra-wideband automotive applications , 2003, Radio and Wireless Conference, 2003. RAWCON '03. Proceedings.

[8]  Rodger E. Ziemer,et al.  Principles of communications , 1976 .

[9]  I. Gresham,et al.  Ultra wide band 24GHz automotive radar front-end , 2003, IEEE MTT-S International Microwave Symposium Digest, 2003.

[10]  Ian Gresham,et al.  A Fast Switching, High Isolation Absorptive SPST SiGe Switch for 24GHz Automotive Applications , 2003, 2003 33rd European Microwave Conference, 2003.

[11]  Theodore S. Rappaport,et al.  The evolution of ultra wide band radio for wireless personal area networks , 2003 .

[12]  D. Schaubert,et al.  Analysis of an aperture coupled microstrip antenna , 1986 .

[13]  Alexander Yarovoy.  Ultra-Wideband Systems , 2003, 2003 33rd European Microwave Conference, 2003.

[14]  J. R. Hoffman,et al.  Addendum to NTIA Report 01-384: Measurements to Determine Potential Interference to GPS Receivers from Ultrawideband Transmission Systems , 2001 .

[15]  D.J. Edwards,et al.  Optimal system design considerations for the ultra-wideband multipath channel , 2005, VTC-2005-Fall. 2005 IEEE 62nd Vehicular Technology Conference, 2005..

[16]  William C. Morchin.  Radar Engineer's Sourcebook , 1992 .

[17]  Gabriel M. Rebeiz,et al.  Compact Low Phase-Noise 23 GHz VCO Fabricated in a Commercial SiGe Bipolar Process , 2003, 2003 33rd European Microwave Conference, 2003.

[18]  I. Gresham,et al.  A fast switching, high isolation absorptive SPST SiGe switch for 24 GHz automotive applications , 2003, 33rd European Microwave Conference Proceedings (IEEE Cat. No.03EX723C).

[19]  J.-F. Luy,et al.  A sensor system based on SiGe MMICs for 24 GHz automotive applications , 2001, 2001 IEEE MTT-S International Microwave Sympsoium Digest (Cat. No.01CH37157).

[20]  I. Gresham,et al.  Ultra wide band 24 GHz automotive radar front-end , 2003, IEEE Radio Frequency Integrated Circuits (RFIC) Symposium, 2003.

[21]  J. Cressler.  SiGe HBT technology: a new contender for Si-based RF and microwave circuit applications , 1998 .

[22]  U. Shankar,et al.  MOTOR VEHICLE TRAFFIC CRASH INJURY AND FATALITY ESTIMATES - 2002 EARLY ASSESSMENT , 2003 .

[23]  M. Vossiek,et al.  24 GHZ SHORT-RANGE MICROWAVE SENSORS FOR INDUSTRIAL AND VEHICULAR APPLICATIONS , 1999 .

[24]  M. Skolnik,et al.  Introduction to Radar Systems , 2021, Advances in Adaptive Radar Detection and Range Estimation.

[25]  Eng Chuan Low.  A PLASTIC PACKAGE GaAs MESFET 5.8GHZ RECEIVER FRONT-END WITH ON-CHIP MATCHING FOR ETC SYSTEM , 1999, RFIC 1999.

[26]  R. Michael Buehrer,et al.  Ultra-Wideband Wireless Systems , 2005 .

[27]  H. Schumacher,et al.  A single-chip 24 GHz receiver front-end using a commercially available SiGe HBT foundry process , 2002, 2002 IEEE Radio Frequency Integrated Circuits (RFIC) Symposium. Digest of Papers (Cat. No.02CH37280).

[28]  A. Stelzer,et al.  Single-chip 20-GHz VCO and frequency divider in SiGe technology , 2002, 2002 IEEE MTT-S International Microwave Symposium Digest (Cat. No.02CH37278).

[29]  H. I. Fujishiro,et al.  A plastic package GaAs MESFET 5.8 GHz receiver front-end with on-chip matching for ETC system , 1999, 1999 IEEE Radio Frequency Integrated Circuits Symposium (Cat No.99CH37001).