Abstract Refrigerant mixtures may provide some solutions to the problem of the very limited number of fluids which have suitable properties to provide alternatives to CFCs. Mixing of refrigerants allows the adjustment or tuning of the most desirable properties of the mixture by varying the molar fraction of the components. There are three categories of mixtures which can be used as working fluids: azeotropes, near-azeotropes and zeotropes. Azeotropes are usually binary and have long been used in the refrigeration industry; it is unlikely that new combinations will now be found. Near-azeotropes have a much greater potential for development, but under leakage conditions may alter their composition and properties. Near-azeotropes have the most potential as drop-in alternatives to CFCs. Zeotropes have potential for improvements in energy efficiency and capacity modulation, but, as they require hardware design changes can only be considered in new system designs. However, with the long-term concerns about global warming, energy efficiency, and therefore the use of zeotropes, will probably have a great influence on the refrigeration industry.
[1]
M. McLinden,et al.
Experimental evaluation of two refrigerant mixtures in a breadboard air conditioner
,
1988
.
[2]
E. Schlünder,et al.
The influence of liquid-side mass transfer on heat transfer and selectivity during surface and nucleate boiling of liquid mixtures in a falling film
,
1986
.
[3]
T. Midgley.
From the Periodic Table to Production
,
1937
.
[4]
D. Didion,et al.
Quest for alternatives
,
1987
.
[5]
R. Reid,et al.
The Properties of Gases and Liquids
,
1977
.
[6]
E. Vineyard,et al.
Selection of ozone-safe, nonazeotropic refrigerant mixtures for capacity modulation in residential heat pumps
,
1989
.
[7]
D. Gorenflo,et al.
Heat Transfer at Pool Boiling of Mixtures with R 22 and R 115
,
1986
.