CFD investigation of hydrodynamics, heat transfer and cracking reaction in a heavy oil riser with bottom airlift loop mixer

Abstract This paper presents a CFD modeling of hydrodynamics, heat transfer and cracking reaction in a heavy oil riser together with a bottom airlift loop mixer. By extending a validated gas–solid flow model to incorporate feedstock vaporization and 12-lump kinetic model, a three-phase flow and reaction model is established. CFD analysis is performed, and the effects of operating parameters are thus evaluated. The results indicate that the bottom airlift loop mixer causes the hot and the cool catalyst well mix and obtains a uniform catalyst temperature at riser inlet. There exists optimal product distribution, with a maximum light liquid yield at about 30.0 m of up the riser. Product yields are more sensitive to injection angle than to feedstock droplet size and reaction temperature. A catalyst-to-oil ratio in the range of 7–8 and a shorter reaction time of 3.02 s are preferable for a higher light liquid yield.

[1]  D. Gidaspow.  Multiphase Flow and Fluidization: Continuum and Kinetic Theory Descriptions , 1994 .

[2]  R. Jackson,et al.  Gas‐particle flow in a vertical pipe with particle‐particle interactions , 1989 .

[3]  D. Gunn.  Transfer of heat or mass to particles in fixed and fluidised beds , 1978 .

[4]  S. Patankar.  Numerical Heat Transfer and Fluid Flow , 2018, Lecture Notes in Mechanical Engineering.

[5]  A. Lygeros,et al.  Feedstock atomization effects on FCC riser reactors selectivity , 1999 .

[6]  D. Subba Rao,et al.  Model for the performance of a fluid catalytic cracking (FCC) riser reactor: effect of feed atomization , 2001 .

[7]  Xingying Lan,et al.  CFD modeling of gas-solid flow and cracking reaction in two-stage riser FCC reactors , 2009 .

[8]  Ye-Mon Chen,et al.  Recent advances in FCC technology , 2006 .

[9]  Yincheng Guo,et al.  Simulations of gas‐liquid‐solid 3‐phase flow and reaction in FCC riser reactors , 2001 .

[10]  Vivek V. Ranade,et al.  Modeling of vaporization and cracking of liquid oil injected in a gas¿solid riser , 2005 .

[11]  Ajay Gupta,et al.  Effect of feed atomization on FCC performance: simulation of entire unit , 2003 .

[12]  Chunxi Lu,et al.  Experiments and simulations of gas–solid flow in an airlift loop reactor , 2011 .

[13]  Shan Honghong,et al.  Experimental study of two-stage riser FCC reactions , 2001 .

[14]  Gang Wang,et al.  A novel conceptional process for residue catalytic cracking and gasoline reformation dual-reactions mutual control , 2008 .

[15]  Suzanne L. Holcombe.  National Technical Information Service , 2008 .

[16]  Yong Jin,et al.  Numerical simulation of the gas-particle turbulent flow in riser reactor based on k-ε-kp-εp-Θ two-fluid model , 2001 .

[17]  Bolun Yang,et al.  New FCC process minimizes gasoline olefin, increases propylene , 2003 .

[18]  Shahrokh Shahhosseini,et al.  CFD analysis of hydrodynamic, heat transfer and reaction of three phase riser reactor , 2011 .

[19]  Syamlal.  The particle-particle drag term in a multiparticle model of fluidization , 1987 .