STUCK FAULT AND CURRENT TESTING COMPARISON USING CMOS CHIP TEST

This paper compares the effectiveness of Stuck Fault and Current Testing, as applied to CMOS ICs. The comparison is performed by testing sequential CMOS chips using patterns developed via both methodis, and evaluating their ability to identify faulty prciduct. The test results are then contrasted to a previous study in which a smaller, combinatorial chip was tested by the same means. The results indicate that, for the investigated set of chips, Current Testing provides a better screen of defective product for some classes of defects, while Stuck Fault Testing is more effective on others.

[1]  Wojciech Maly,et al.  Realistic Fault Modeling for VLSI Testing , 1987, 24th ACM/IEEE Design Automation Conference.

[2]  Wojciech Maly,et al.  Built-in current testing-feasibility study , 1988, [1988] IEEE International Conference on Computer-Aided Design (ICCAD-89) Digest of Technical Papers.

[3]  Randal E. Bryant,et al.  Test Pattern Generation for Sequential MOS Circuits by Symbolic Fault Simulation , 1989, 26th ACM/IEEE Design Automation Conference.

[4]  Wojciech Maly,et al.  Test generation for current testing , 1989, [1989] Proceedings of the 1st European Test Conference.

[5]  F. Brglez,et al.  A neutral netlist of 10 combinational benchmark circuits and a target translator in FORTRAN , 1985 .

[6]  R. Keith Treece,et al.  Increased CMOS IC stuck-at fault coverage with reduced I/sub DDQ/ test sets , 1990, Proceedings. International Test Conference 1990.

[7]  Yves Crouzet,et al.  Physical Versus Logical Fault Models MOS LSI Circuits: Impact on Their Testability , 1980, IEEE Transactions on Computers.

[8]  Wojciech Maly,et al.  CMOS bridging fault detection , 1990, Proceedings. International Test Conference 1990.

[9]  Theodore M. Booth Demonstrating hazards in sequential relay circuits , 1963, SWCT.

[10]  Wojciech Maly,et al.  Testing oriented analysis of CMOS ICs with opens , 1988, [1988] IEEE International Conference on Computer-Aided Design (ICCAD-89) Digest of Technical Papers.

[11]  John A. Newkirk,et al.  An Algorithm to Generate Tests for MOS Circuits at the Switch Level , 1985, ITC.

[12]  J. M. Soden,et al.  Electrical properties and detection methods for CMOS IC defects , 1989, [1989] Proceedings of the 1st European Test Conference.

[13]  Tracy Larrabee,et al.  Testing for parametric faults in static CMOS circuits , 1990, Proceedings. International Test Conference 1990.

[14]  R. L. Wadsack,et al.  Fault modeling and logic simulation of CMOS and MOS integrated circuits , 1978, The Bell System Technical Journal.