Torque-ripple minimization with indirect position and speed sensing for switched reluctance motors

A torque-ripple-minimization controller is realized along with indirect position and speed sensing for switched reluctance motors (SRMs). The position and speed estimations are derived from a sliding-mode observer that requires terminal measurements of only phase voltages and currents. The research shows that position- and speed-sensorless observers can be reliably used for control of an SRM. Experimental results using a four-phase, 8/6 SRM and the TMS320C30 digital signal processor are presented. The results demonstrate position- and speed-sensorless closed-loop operation of a torque-ripple-minimized SRM drive.

[1]  Ching Chuen Chan,et al.  A novel sliding-mode observer for indirect position sensing of switched reluctance motor drives , 1999, IEEE Trans. Ind. Electron..

[2]  R. Krishnan,et al.  Switched Reluctance Motor Drives , 2019 .

[3]  I. Husain,et al.  Torque ripple minimization in switched reluctance machines over a wide speed range , 1997, IAS '97. Conference Record of the 1997 IEEE Industry Applications Conference Thirty-Second IAS Annual Meeting.

[4]  Corrado Guarino Lo Bianco,et al.  Modeling and control strategies for a variable reluctance direct-drive motor , 1993, IEEE Trans. Ind. Electron..

[5]  A. V. Radun,et al.  Design considerations for the switched reluctance motor , 1994, Proceedings of 1994 IEEE Industry Applications Society Annual Meeting.

[6]  Takeshi Furuhashi,et al.  Design of sliding observer for estimation of rotor flux of induction motors , 1990 .

[7]  Iqbal Husain,et al.  A sliding mode observer based controller for switched reluctance motor drives , 1994, Proceedings of 1994 IEEE Industry Applications Society Annual Meeting.

[8]  S.R. MacMinn,et al.  Flux-current methods for SRM rotor position estimation , 1991, Conference Record of the 1991 IEEE Industry Applications Society Annual Meeting.

[9]  Jeffrey H. Lang,et al.  State observers for variable-reluctance motors , 1990 .

[10]  Roland J. Hill,et al.  Detection of Rotor Position in Stepping and Switched Motors by Monitoring of Current Waveforms , 1985, IEEE Transactions on Industrial Electronics.

[11]  S. Peresada,et al.  Feedback linearizing control of switched reluctance motors , 1987 .