In a rollover, the lap part of the 3-point belt certainly restrains the occupant from being fully ejected out of the vehicle, however the upper torso of the far side occupant may slip out of the shoulder belt. In this study the combination of reversed 3-point belt geometry (seat integrated), inboard torso side-support and buckle pretensioner were evaluated regarding the ability to better restrain the upper torso to the seat to prevent head-to-interior impacts. The method of evaluation, proposed and used in this paper, was a new sled test method simulating full-scale tripped rollovers along the longitudinal axis during the initial phase of tripping, the airborne phase and the first ground impact. The roof was assumed in the tests to be able to withstand the ground impact. Since car occupants normally are seated with a certain kyfosis and may straighten and elongate their spine, standard HIII ATDs were modified with 3D-flexible lumbar spines and used in both front seat positions. As a result, the rollover sled test method worked properly with good repeatability. While the head of the non-leading side (far-side) dummy impacted the inner roof in the standard 3-point belt configuration, the seat integrated 3-point belt with reversed geometry and buckle pretensioner showed ability to restrain the torso from moving inboard and towards the roof during the rollover tests.
[1]
Chantal S. Parenteau,et al.
Driver Injuries in US Single-Event Rollovers
,
2000
.
[2]
D Otte,et al.
Kinematics and injury pattern in rollover accidents of cars in German road traffic – an in-depth-analysis by GIDAS
,
2005
.
[3]
Richard Frampton,et al.
Vehicle rollover: an important element in multiple impact crashes
,
2003
.
[4]
Ola Boström,et al.
Benefits of a 3+2 point belt system and an inboard torso side support in frontal, far-side and rollover crashes
,
2003
.
[5]
A M Eigen,et al.
CRASH ATTRIBUTES THAT INFLUENCE THE SEVERITY OF ROLLOVER CRASHES. IN: OCCUPANT AND VEHICLE RESPONSES IN ROLLOVERS
,
2004
.
[6]
David C. Viano,et al.
Rollover Crash Sensing and Safety Overview
,
2004
.
[7]
Mark D. Brown,et al.
Measurement of Cadaver Lumbar Spine Motion Segment Stiffness
,
2002,
Spine.
[8]
Dimitrios Kallieris,et al.
NECK RESPONSE AND INJURY ASSESSMENT USING CADAVERS AND THE US-SID FOR FAR-SIDE LATERAL IMPACTS OF REAR SEAT OCCUPANTS WITH INBOARD-ANCHORED SHOULDER BELTS
,
1990
.
[9]
Mike Rossey.
Test method for simulating vehicle rollover
,
2001
.