noise in polymer thick-film resistors

noise properties of carbon black/polyesterimide and (carbon )/polyesterimide thick-film resistors are studied. In resistive inks either high-structure carbon black or medium-structure carbon black was used. The influence of the content p of carbon black and graphite in resistive inks and curing temperature on sheet resistance and noise intensity C is considered. It is shown that a higher curing temperature causes a decrease in the resistor's volume and influences and C indirectly, via changes of the parameter p. It is then found that an increase in p leads to a simultaneous decrease of sheet resistance and noise intensity C. The relation is found in this case for all measured resistors. The values of noise exponent are estimated and a comparison with the noise properties of conventional cermet thick-film resistors is made. It is shown that the noise intensities of carbon black/polyesterimide resistors are comparable to those of cermet resistors.

[1]  John Clarke,et al.  Flicker (1f) noise: Equilibrium temperature and resistance fluctuations , 1976 .

[2]  Carleton H. Seager,et al.  Electrical properties and conduction mechanisms of Ru‐based thick‐film (cermet) resistors , 1977 .

[3]  Ping Sheng,et al.  Fluctuation-Induced Tunneling Conduction in Carbon-Polyvinylchloride Composites , 1978 .

[4]  L.K.J. Vandamme,et al.  Experimental studies on 1/f noise , 1981 .

[5]  Shen-Li Fu,et al.  Electrical Characteristics of Polymer Thick Film Resistors, Part I: Experiemental Results , 1981 .

[6]  W. H. Jeu,et al.  Conduction mechanisms and 1/f noise in thick‐film resistors with Pb3Rh7O15and Pb 2Ru2O7 , 1981 .

[7]  W. Webb,et al.  Exclusion of temperature fluctuations as the source of 1f noise in metal films , 1981 .

[8]  R. Rammal Flicker noise near the percolation threshold , 1985 .

[9]  M. Wolf,et al.  Comment on the Dependence of R□ and Current Noise on Grain Size inThick Film Resistors (TFR's) , 1985 .

[10]  Miyoshi Haradome,et al.  Conductive and Insulative Particle Size Effects on the Electrical Properties of RuO 2 Thick-Film Resistors , 1985 .

[11]  Fernández,et al.  Proton decay in a nucleus: Effects of the nuclear surface. , 1986, Physical review. D, Particles and fields.

[12]  L. Vandamme Comments on "An exact formula for the effects of resistor geometry on current noise" , 1986 .

[13]  Andrzej Kusy,et al.  On 1f noise in RuO2-based thick resistive films , 1986 .

[14]  D. P. Levinson,et al.  An exact formula for the effects of resistor geometry on current noise , 1986, IEEE Transactions on Electron Devices.

[15]  Feng,et al.  Transport properties of continuum systems near the percolation threshold. , 1987, Physical review. B, Condensed matter.

[16]  G. Mey Comments on "An exact formula for the effects of resistor geometry on current noise" , 1987 .

[17]  A. Kolek,et al.  Critical exponents for conductance and 1/f noise in discrete-lattice percolation , 1988 .

[18]  F. Müller,et al.  DEPENDENCE OF THE SHEET RESISTIVITY AND CURRENT NOISE BEHAVIOUR OF THE GRAIN SIZE AND VOLUME FRACTION OF CONDUCTING MATERIAL IN THICK-FILM RESISTORS EXPERIMENTS , 1988 .

[19]  Rammal,et al.  Electrical-conduction mechanisms in polymer-copper-particle composites. II. (1/f)-noise measurements in the percolation limit. , 1990, Physical review. B, Condensed matter.

[20]  K Bobran,et al.  An experimental verification of a percolation model for RuO2-glass thick resistive films , 1991 .

[21]  Andrzej Dziedzic,et al.  Further examinations of carbon/polyesterimide thick-film resistors , 1993 .

[22]  M. Tamborin,et al.  Excess Noise in Thick Film Resistors: Volume Dependence , 1995 .

[23]  Safa Kasap,et al.  1/f noise in bismuth ruthenate based thick-film resistors , 1997 .

[24]  M. Tamborin,et al.  Piezoresistive properties of RuO2-based thick-film resistors: the effect of RuO2 grain size , 1997 .

[25]  Christian Jung,et al.  Current noise of trimmed thick‐film resistors: measurement and simulation , 1998 .