Mineralogy and Isotope Geochemistry of Active Submarine Hydrothermal Field at Suiyo Seamount, Izu–Bonin Arc, West Pacific Ocean

This report presents mineralogical, geochemical and isotopic data on samples obtained using the Benthic Multi‐coring System (BMS) to drill a submarine hydrothermal deposit developed in a caldera on the summit of the Suiyo Seamount in the Izu–Bonin Island Arc, south of Japan. This deposit is regarded as the first example of Kuroko‐type sulfide mineralization on a volcano at the volcanic front of an island arc. The mineralization and hydrothermal alteration below the 300 × 150‐m area of active venting was investigated to depths of 2–9 m below the sea floor. Drilling beneath the area of active venting recovered a sequence of altered volcanic rocks (dacite lavas, pyroclastic rocks of dacite–rhyolite compositions and pumice) associated with sulfide veining and patches/veins of anhydrite. No massive sulfide was found, however, and the subsea‐floor mineralization to 10 m depth is dominated by anhydrite and clay minerals with some sulfides. Sulfide‐bearing samples contained high Au (up to 42 ppm), Ag (up to 263 ppm), As (up to 1550 ppm), Hg (up to 55 ppm), Sb (up to 772 ppm), and Se (up to 24 ppm). Electron probe microanalyzer indicated that realgar, orpiment, and mimetite were major As‐bearing minerals. The sulfides were also characterized by high Zn (>10%) compared to Cu (<6.3%) and Pb (<0.6%). The δ202Hg/198Hg, δ202Hg/199Hg and δ202Hg/200Hg of the sulfide‐bearing dacite samples and a sulfide chimney decreased with increasing Hg/Zn concentration ratio. The variation of the δ202Hg/198Hg ranged from −2.8 to +0.5‰ to relative to S‐HG02027. The large range of these δ202Hg/198Hg was greater than might be expected for such a heavy element and may be due to a predominance of kinetic effects. The variation of δ202Hg/198Hg of sulfide‐bearing dacite samples suggested that light Hg isotope in the vapor mixed with oxygenated seawater near sea floor during mineralization. Lead isotope ratios of the sulfide were very similar to those of the dacite lava, suggesting that lead is of magmatic origin. The 87Sr/86Sr ratio (0.70872) of anhydrite was different from that of the dacite lava, and suggests an Sr derivation predominantly from seawater. Hydrothermal alteration of the dacite in the Suiyo hydrothermal field was characterized by Fe‐sulfides, anhydrite, barite, montmorillonite, chlorite/montmorillonite mixed‐layer minerals, mica, and chlorite with little or no feldspar or cristobalite. Hydrothermal clay minerals changed with depth from montmorillonite to chlorite/montmorillonite mixed‐layer minerals to chlorite and mica. Hydrogen isotope ratios of chlorite/montmorillonite and mixed‐layer, mica‐chlorite composites obtained below the active venting sites ranged from −49 to −24‰, suggesting seawater as the dominant fluid causing alteration. Oxygen isotope ratios of anhydrite ranged from 9.2 to 10.4‰ and anhydrite formation temperatures were calculated to be 188–207°C. Oxygen isotope ratios ranged from +5.2 to +9.2‰ for montmorillonite, +3.2 to +4.5‰ for chlorite/montmorillonite mixed‐layer minerals, and +2.8 to +3.8‰ in mixtures of chlorite and mica. The formation temperatures of montmorillonite and of the chlorite–mica mixture were 160–250°C and 230–270°C, respectively. The isotope temperatures for clay minerals (220–270°C) and anhydrite (188°C) were significantly lower than the borehole temperature (308.3°C) measured just after the drilling, suggesting that temperature at this site is now higher than when clay minerals and anhydrite were formed.