Studies on thermal properties and thermal control effectiveness of a new shape-stabilized phase change material with high thermal conductivity

Abstract In order to overcome the difficulty of conventional phase change materials (PCMs) in packaging, the shape-stabilized PCMs are proposed to be used in the electronic device thermal control. However, the conventional shape-stabilized PCMs have the drawback of lower thermal conductivity, so a new shape-stabilized PCM with high thermal conductivity, which is suitable for thermal control of electronic devices, is prepared. The thermal properties of n-octadecane-based shape-stabilized PCM are tested and analyzed. The heat storage/release performance is studied by numerical simulation. Its thermal control effect for electronic devices is also discussed. The results show that the expanded graphite (EG) can greatly improve the thermal conductivity of the material with little effect on latent heat and phase change temperature. When the mass fraction of EG is 5%, thermal conductivity has reached 1.76 W/(m K), which is over 4 times than that of the original one. Moreover, the material has larger latent heat and good thermal stability. The simulation results show that the material can have good heat storage/release performance. The analysis of the effect of thermal parameters on thermal control effect for electronic devices provides references to the design of phase change thermal control unit.

[1]  Cristina H. Amon,et al.  PCM thermal control unit for portable electronic devices: experimental and numerical studies , 2003 .

[2]  Xu Xu,et al.  Modeling and simulation of under-floor electric heating system with shape-stabilized PCM plates , 2004 .

[3]  L. T. Yeh,et al.  Review of Heat Transfer Technologies in Electronic Equipment , 1995 .

[4]  F. Tan,et al.  Cooling of portable hand-held electronic devices using phase change materials in finned heat sinks , 2010 .

[5]  Jun Wang,et al.  Heat conduction enhanced shape-stabilized paraffin/HDPE composite PCMs by graphite addition: Preparation and thermal properties , 2010 .

[6]  R. Kizilel,et al.  Passive thermal management using phase change material (PCM) for EV and HEV Li- ion batteries , 2005, 2005 IEEE Vehicle Power and Propulsion Conference.

[7]  Thomas O. Leimkuehler,et al.  Thermal Vacuum Test of Ice as a Phase Change Material Integrated with a Radiator , 2010 .

[8]  Yi Jiang,et al.  Preparation, thermal performance and application of shape-stabilized PCM in energy efficient buildings , 2006 .

[9]  Ryan A. Stephan,et al.  Development, Testing, and Failure Mechanisms of a Replicative Ice Phase Change Material Heat Exchanger , 2010 .

[10]  F. Tan,et al.  Thermal Management of Mobile Phone using Phase Change Material , 2007, 2007 9th Electronics Packaging Technology Conference.

[11]  Ryan A. Stephan,et al.  Phase Change Material Heat Exchanger Life Test , 2009 .

[12]  Na Zhu,et al.  Dynamic characteristics and energy performance of buildings using phase change materials: A review , 2009 .

[13]  J. Selman,et al.  Thermal management of Li-ion battery with phase change material for electric scooters: experimental validation , 2005 .

[14]  Min Xiao,et al.  Preparation and performance of shape stabilized phase change thermal storage materials with high thermal conductivity , 2002 .