Sensor Integration on Additively Manufactured Hot Section Components for Wireless Gas Turbine Prognostics

[1]  W. Smith,et al.  Direct‐Write Strain and Temperature Sensors for Harsh Environments , 2007 .

[2]  P. Peyre,et al.  Influence of SLM process parameters on the surface finish, porosity rate and fatigue behavior of as-built Inconel 625 parts , 2017 .

[3]  D. Paulonis,et al.  Alloy 718 at Pratt & Whitney: Historical Perspective and Future Challenges , 2001 .

[4]  Sen Wang,et al.  Experimental investigation on densification behavior and surface roughness of AlSi10Mg powders produced by selective laser melting , 2017 .

[5]  K. Thole,et al.  Effects of Geometry, Spacing, and Number of Pin Fins in Additively Manufactured Microchannel Pin Fin Arrays , 2018 .

[6]  Sanjay Sampath,et al.  Embedded resistive strain sensors for harsh environments , 2006, 2006 IEEE Aerospace Conference.

[7]  Karen A. Thole,et al.  Scaling Roughness Effects on Pressure Loss and Heat Transfer of Additively Manufactured Channels , 2017 .

[8]  Sagar Patel,et al.  Towards understanding side-skin surface characteristics in laser powder bed fusion , 2020, Journal of Materials Research.

[9]  Manyalibo J. Matthews,et al.  In situ measurements of layer roughness during laser powder bed fusion additive manufacturing using low coherence scanning interferometry , 2018, Materials & Design.

[10]  Brandon M. Lane,et al.  Effect of Process Parameters on the Surface Roughness of Overhanging Structures in Laser Powder Bed Fusion Additive Manufacturing , 2016 .

[11]  N. N. Kumbhar,et al.  Post Processing Methods used to Improve Surface Finish of Products which are Manufactured by Additive Manufacturing Technologies: A Review , 2018 .

[12]  Karen A. Thole,et al.  Roughness Effects on Flow and Heat Transfer for Additively Manufactured Channels , 2016 .

[13]  F. Caiazzo,et al.  Laser powder-bed fusion of Inconel 718 to manufacture turbine blades , 2017 .

[14]  Jacob C. Snyder,et al.  Understanding Laser Powder Bed Fusion Surface Roughness , 2020 .

[15]  R. E. Schafrik,et al.  Application of Alloy 718 in GE Aircraft Engines: Past, Present and Next Five Years , 2001 .

[16]  Karen A. Thole,et al.  Build Direction Effects on Microchannel Tolerance and Surface Roughness , 2015 .

[17]  Jian H. Yu,et al.  Effect of scan pattern on the microstructure and mechanical properties of Powder Bed Fusion additive manufactured 17-4 stainless steel , 2017 .

[18]  Karen A. Thole,et al.  Build Direction Effects on Additively Manufactured Channels , 2015 .