Automated Video Exposure Assessment of Repetitive Motion

A new method is described for automatically quantifying repetitive hand motion using digital video processing. The hand activity level (HAL) is widely used for evaluating repetitive hand work. Conventional methods using either a trained observer on site, or manual off site video analysis, are often considered inaccurate, cumbersome or impractical for routine work assessment. A simple paced load transfer task was used to simulate a repetitive industrial activity. Twelve participants were videoed performing the task for varying HAL conditions. The automatically predicted HAL was compared to the ground truth HAL measured using manual frame-by-frame video analysis. Hand kinematics using the marker-less single-camera video tracking algorithm were compared against an infrared 3D motion tracking system. This paper demonstrates proof-of-concept for automatic video-based direct exposure assessment.

[1]  P. Jonsson,et al.  Comparison of measurement accuracy between two types of wrist goniometer systems. , 2001, Applied ergonomics.

[2]  N. Fallentin,et al.  Assessment of work postures and movements using a video-based observation method and direct technical measurements. , 2001, Applied ergonomics.

[3]  Stephen Bao,et al.  The natural course of carpal tunnel syndrome in a working population. , 2010, Scandinavian journal of work, environment & health.

[4]  R G Radwin,et al.  Comparison between using spectral analysis of electrogoniometer data and observational analysis to quantify repetitive motion and ergonomic changes in cyclical industrial work , 2000, Ergonomics.

[5]  W S Marras,et al.  Wrist motions in industry. , 1993, Ergonomics.

[6]  Stephen Bao,et al.  Quantitative exposure-response relations between physical workload and prevalence of lateral epicondylitis in a working population. , 2009, American journal of industrial medicine.

[7]  S H Snook,et al.  A single metric for quantifying biomechanical stress in repetitive motions and exertions. , 1997, Ergonomics.

[8]  Matthew M. Marshall,et al.  The Effects of Complex Wrist and Forearm Posture on Wrist Range of Motion , 1999, Hum. Factors.

[9]  William S. Marras,et al.  Dynamic capabilities of the wrist joint in industrial workers , 1993 .

[10]  David Rempel,et al.  1st place, PREMUS best paper competition: workplace and individual factors in wrist tendinosis among blue-collar workers--the San Francisco study. , 2011, Scandinavian journal of work, environment & health.

[11]  S S Ulin,et al.  Development and evaluation of an observational method for assessing repetition in hand tasks. , 1997, American Industrial Hygiene Association journal.

[12]  Bryan Buchholz,et al.  Practical Operation of a Biaxial Goniometer at the Wrist Joint , 1997, Hum. Factors.

[13]  Steve Wurzelbacher,et al.  A Comparison of Assessment Methods of Hand Activity and Force for Use in Calculating the ACGIH® Hand Activity Level (HAL) TLV® , 2010, Journal of occupational and environmental hygiene.

[14]  R G Radwin,et al.  Agreement between a frequency-weighted filter for continuous biomechanical measurements of repetitive wrist flexion against a load and published psychophysical data. , 1998, Ergonomics.

[15]  M L Lin,et al.  Exposure assessment of biomechanical stress in repetitive manual work using frequency-weighted filters. , 1994, Ergonomics.

[16]  M L Lin,et al.  Validation of a frequency-weighted filter for continuous biomechanical stress in repetitive wrist flexion tasks against a load. , 1998, Ergonomics.