On the elastic deformation properties of porous ceramic materials obtained by pore-forming agent method

Abstract The influence of the pore size distribution on the elastic modulus has been studied using an intermingled fractal model (IFU) capable to reproduce entirely pore size distribution of materials. The results obtained from IFU modelling are in good agreement with experimental ones. The model could be considered as a microstructure simulator to improve mechanical properties of porous ceramic materials.

[1]  A. Nakajima,et al.  Preparation and properties of porous alumina ceramics with oriented cylindrical pores produced by an extrusion method , 2006 .

[2]  Boming Yu,et al.  A generalized model for the effective thermal conductivity of porous media based on self-similarity , 2004 .

[3]  Larry L. Hench,et al.  Regeneration of trabecular bone using porous ceramics , 2003 .

[4]  Giorgio Pia,et al.  Case studies on the influence of microstructure voids on thermal conductivity in fractal porous media , 2014 .

[5]  H. Cui,et al.  Preparation of porous mullite–corundum ceramics with controlled pore size using bioactive yeast as pore-forming agent , 2014 .

[6]  Jinhuai Liu,et al.  A study on preparation of cordierite gradient pores porous ceramics from rectorite , 2011 .

[7]  Michele Dondi,et al.  Predicting the initial rate of water absorption in clay bricks , 2009 .

[8]  Giorgio Pia,et al.  Intermingled fractal units model and electrical equivalence fractal approach for prediction of thermal conductivity of porous materials , 2013 .

[9]  Sa Li,et al.  Effect of starch addition on microstructure and properties of highly porous alumina ceramics , 2013 .

[10]  Haiyan Du,et al.  Porous silica ceramics with relatively high strength and novel bi-modal pore structure prepared by a TBA-based gel-casting method , 2012 .

[11]  G. Bentley,et al.  The growth of chondrocytes using Gelfoam® as a biodegradable scaffold , 1995 .

[12]  G. Meng,et al.  Low cost porous mullite-corundum ceramics by gelcasting , 2001 .

[13]  Shujing Li,et al.  Processing and microstructure characterization of porous corundum–spinel ceramics prepared by in situ decomposition pore-forming technique , 2008 .

[14]  Jiangbo Wen,et al.  Porosity and Oxide Layer Dependence of Thermal Shock Behavior of Porous Silicon Nitride Ceramics , 2014 .

[15]  Hyoun‐Ee Kim,et al.  Effect of Polystyrene Addition on Freeze Casting of Ceramic/Camphene Slurry for Ultra‐High Porosity Ceramics with Aligned Pore Channels , 2006 .

[16]  W. Xing,et al.  Design and preparation of high permeability porous mullite support for membranes by in-situ reaction , 2015 .

[17]  C. Atzeni,et al.  A fuzzy model for classifying mechanical properties of vesicular basalt used in prehistoric buildings , 2008 .

[18]  Xiangyun Hu,et al.  Generalized modeling of spontaneous imbibition based on Hagen-Poiseuille flow in tortuous capillaries with variably shaped apertures. , 2014, Langmuir : the ACS journal of surfaces and colloids.

[19]  Pengfei Lu,et al.  Role of pore structure on liquid flow behaviors in porous media characterized by fractal geometry , 2014 .

[20]  F. Jin,et al.  Gas permeability and adsorbability of the glass-bonded porous silicon carbide ceramics with controlled pore size , 2015 .

[21]  Zongjin Li,et al.  Assessment of steady state diffusion of volatile organic compounds in unsaturated building materials based on fractal diffusion model , 2015 .

[22]  M. Nogami,et al.  Macroporous calcium phosphate glass-ceramic prepared by two-step pressing technique and using sucrose as a pore former , 2005, Journal of materials science. Materials in medicine.

[23]  M. Viana,et al.  Fabrication of porous substrates: a review of processes using pore forming agents in the biomaterial field. , 2008, Journal of pharmaceutical sciences.

[24]  Kenneth Falconer,et al.  Fractal Geometry: Mathematical Foundations and Applications , 1990 .

[25]  Giorgio Pia,et al.  An intermingled fractal units model and method to predict permeability in porous rock , 2014 .

[26]  S. Kamali-Bernard,et al.  Performance simulation and quantitative analysis of cement-based materials subjected to leaching , 2010 .

[27]  Bui Hoang Bac,et al.  Humidity control porous ceramics prepared from waste and porous materials , 2011 .

[28]  Haiyan Du,et al.  Preparation of porous Y2SiO5 ceramics with relatively high compressive strength and ultra-low thermal conductivity by a TBA-based gel-casting method , 2013 .

[29]  Wei Liu,et al.  Al2O3 ceramics with well-oriented and hexagonally ordered pores: The formation of microstructures and the control of properties , 2012 .

[30]  Benoit B. Mandelbrot,et al.  Fractal Geometry of Nature , 1984 .

[31]  Y. Ju,et al.  Influence of pore structures on the mechanical behavior of low-permeability sandstones: numerical reconstruction and analysis , 2014 .

[32]  J. Labrincha,et al.  Ceramic tiles with controlled porosity and low thermal conductivity by using pore-forming agents , 2014 .

[33]  C. Atzeni,et al.  Surface wear resistance of chemically or thermally stabilized earth-based materials , 2008 .

[34]  P. Xu,et al.  A Generalized Model for the Effective Thermal Conductivity of Unsaturated Porous Media Based on Self-Similarity , 2007 .

[35]  Francesco Baino,et al.  Ceramics for oculo-orbital surgery , 2015 .

[36]  R. D. T. Filho,et al.  The effects of the early carbonation curing on the mechanical and porosity properties of high initial strength Portland cement pastes , 2015 .

[37]  Ana Guerrero,et al.  Mechanical properties, pore size distribution, and pore solution of fly ash-belite cement mortars , 1999 .

[38]  Giorgio Pia,et al.  Fractal modelling of medium–high porosity SiC ceramics , 2008 .

[39]  Giorgio Pia,et al.  Porous ceramic materials by pore-forming agent method: An intermingled fractal units analysis and procedure to predict thermal conductivity , 2015 .

[40]  W. Pabst,et al.  Porous ceramics prepared using PoPPy seed as a pore-forming agent , 2007 .

[41]  Xiangyun Deng,et al.  Fabrication and properties of cordierite–mullite bonded porous SiC ceramics , 2014 .

[42]  Boming Yu,et al.  A fractal streaming current model for charged microscale porous media , 2014 .

[43]  Elisa Rambaldi,et al.  Acoustic and thermal performances of ceramic tiles and tiling systems , 2015 .

[44]  Giorgio Pia,et al.  An intermingled fractal units model to evaluate pore size distribution influence on thermal conductivity values in porous materials , 2014 .

[45]  J. Buiting,et al.  Permeability from porosimetry measurements: Derivation for a tortuous and fractal tubular bundle , 2013 .

[46]  Giorgio Pia,et al.  A geometrical fractal model for the porosity and thermal conductivity of insulating concrete , 2013 .

[47]  Yuping Zeng,et al.  High-strength porous Si3N4 ceramics prepared by freeze casting and silicon powder nitridation process , 2014 .

[48]  Zhanghua Wu,et al.  Preparation and properties of reticulated porous γ-Y2Si2O7 ceramics with high porosity and relatively high strength , 2014 .

[49]  Edward J. Garboczi,et al.  Elastic Properties of Model Porous Ceramics , 2000, cond-mat/0006334.

[50]  Xudong Chen,et al.  Influence of porosity on compressive and tensile strength of cement mortar , 2013 .

[51]  Jang-Hoon Ha,et al.  A novel method of coating a particle-stabilized alumina foam on a porous alumina substrate , 2012 .

[52]  Gang Wang,et al.  Fabrication and microstructure of porous SiC ceramics using suspension emulsions as pore-forming agents , 2014 .

[53]  J MEAD,et al.  Mechanical properties of lungs. , 1961, Physiological reviews.

[54]  Zijun Hu,et al.  Thermal and mechanical properties of fibrous zirconia ceramics with ultra-high porosity , 2014 .

[55]  R. M. Khattab,et al.  Preparation and characterization of porous alumina ceramics through starch consolidation casting technique , 2012 .

[56]  N. Xie,et al.  Mechanical properties of cermet composites with various geometrical tortuosity of metal phase: Fractal characterization , 2014 .

[57]  Peng Xu,et al.  Prediction of relative permeability in unsaturated porous media with a fractal approach , 2013 .

[58]  Wei Liu,et al.  Effects of sintering behavior on piezoelectric properties of porous PZT ceramics , 2014 .

[59]  Jiafei Zhao,et al.  Fractal analysis and its impact factors on pore structure of artificial cores based on the images obtained using magnetic resonance imaging , 2012 .

[60]  Wei Sun,et al.  Fractal and multifractal analysis on pore structure in cement paste , 2014 .

[61]  M. Z. Abdullah,et al.  Sago starch as binder and pore-forming agent for the fabrication of porcelain foam , 2014 .

[62]  Roland N. Horne,et al.  Fractal modeling of capillary pressure curves for The Geysers rocks , 2006 .

[63]  Shan Qiu,et al.  Novel freeze-casting fabrication of aligned lamellar porous alumina with a centrosymmetric structure , 2014 .

[64]  Chi Sun Poon,et al.  Influence of recycled aggregates on long term mechanical properties and pore size distribution of concrete , 2011 .