Novel carbon aerogel-supported catalysts for PEM fuel cell application

Abstract Novel carbon aerogel supported Pt catalysts with different pore size distributions and Pt content have been synthesized and tested in a proton exchange membrane fuel cell (PEMFC) operation. Characterization of the aerogel supported Pt catalyst has been performed in respect to the total surface area of Pt using HRTEM and BET methods, and was compared to the electrochemical surface area of Pt in a cathode layer of the PEMFC by means of cyclic voltammetry. The effect of pore size distribution of the novel aerogel supported Pt catalyst on the performance of the PEMFCs, and kinetic parameters of the catalysts at different temperatures, is discussed in terms of the microstructure of the support and perfluorosulfonate-ionomer distribution. The PEMFC with a low Pt loading (0.1 mg/cm 2 ) of a new porous aerogel catalyst has shown high power densities up to 0.8 mW/cm 2 in fuel cell operation conditions in air and at ambient pressure.

[1]  Timothy C. Stoner,et al.  Increasing Proton Exchange Membrane Fuel Cell Catalyst Effectiveness Through Sputter Deposition , 2002 .

[2]  Makoto Uchida,et al.  Effects of Microstructure of Carbon Support in the Catalyst Layer on the Performance of Polymer‐Electrolyte Fuel Cells , 1996 .

[3]  Zhigang Qi,et al.  Activation of low temperature PEM fuel cells , 2002 .

[4]  João H. Z. Santos,et al.  Indenyl-silica xerogels: new materials for supporting metallocene catalysts , 2001 .

[5]  P. Stonehart,et al.  Sintering and recrystallization of small metal particles. Loss of surface area by platinum-black fuel-cell electrocatalysts , 1972 .

[6]  K. Swider-Lyons,et al.  Transmission Electron Microscopy Studies of the Nanoscale Structure and Chemistry of Pt50Ru50 Electrocatalysts , 2002, Microscopy and Microanalysis.

[7]  A. Kornyshev,et al.  Electrochemical impedance of the cathode catalyst layer in polymer electrolyte fuel cells , 1999 .

[8]  P. Gallezot,et al.  Oxygen reduction on well-defined platinum nanoparticles inside recast ionomer , 1996 .

[9]  Gross,et al.  Elastic nonlinearity of aerogels. , 1992, Physical review. B, Condensed matter.

[10]  J. Fricke,et al.  Planar fibre reinforced carbon aerogels for application in PEM fuel cells , 2001 .

[11]  Nathan P. Siegel,et al.  Single domain PEMFC model based on agglomerate catalyst geometry , 2003 .

[12]  Jean St-Pierre,et al.  Low Cost Electrodes for Proton Exchange Membrane Fuel Cells Performance in Single Cells and Ballard Stacks , 1997 .

[13]  K. Yoshizawa,et al.  Second-order perturbational analysis of the interaction between graphite sheets , 2002 .

[14]  Z. Qi,et al.  Low Pt loading high performance cathodes for PEM fuel cells , 2003 .