A novel capacitive-type humidity sensor using CMOS fabrication technology

Abstract This paper reports a novel capacitive humidity sensor integrated on a polysilicon heater. The sensor was fabricated with the industrial standard CMOS process to achieve a cost-effective solution for accurate and reliability. The sensing material polyimide was obtained by a post-processing step after the standard CMOS fabrication. The sensing principle of the sensor is based on the dielectric constant change of deposited polyimide due to absorption/desorption of vapor. The passivation (silicon nitride) layer with no limitations to the electrode selection is between the electrode and sensing material in order to improve the reliability of the relative humidity for the sensors. The humidity sensor was measured to show a linear dependence on the relative humidity in the range of 20–70%, the maximum hysteresis is 3%.

[1]  T. M. Berlicki,et al.  Thermoelement humidity sensor , 1998 .

[2]  R. Buchhold,et al.  Design studies on piezoresistive humidity sensors , 1998 .

[3]  Carlos Azeredo Leme,et al.  Multi-purpose interface for sensor systems fabricated by CMOS technology with post-processing , 1993 .

[4]  Stavros Chatzandroulis,et al.  Fabrication of single crystal Si cantilevers using a dry release process and application in a capacitive-type humidity sensor , 2002 .

[5]  Henry Baltes,et al.  High sensitivity CMOS humidity sensors with on-chip absolute capacitance measurement system , 1993 .

[6]  J. Thaysen,et al.  Environmental sensors based on micromachined cantilevers with integrated read-out , 2000, Ultramicroscopy.

[7]  K. Watanabe,et al.  A digital hygrometer using a polyimide film relative humidity sensor , 1996 .

[8]  J. Franca,et al.  A CMOS humidity sensor with on-chip calibration , 2001 .

[9]  D. D. Denton,et al.  The long term reliability of a switched-capacitor relative humidity sensor system , 1990, Proceedings of the 33rd Midwest Symposium on Circuits and Systems.

[10]  Khalil Najafi,et al.  A high-sensitivity polyimide capacitive relative humidity sensor for monitoring anodically bonded hermetic micropackages , 2001 .

[11]  Z. M. Rittersma,et al.  Recent achievements in miniaturised humidity sensors—a review of transduction techniques , 2002 .

[12]  Kensall D. Wise,et al.  A high-speed capacitive humidity sensor with on-chip thermal reset , 2000 .

[13]  J. Nevin,et al.  A polyimide-based capacitive humidity sensor , 1985, IEEE Transactions on Electron Devices.