An empirical study on heat transfer and pressure drop characteristics of CuO–base oil nanofluid flow in a horizontal helically coiled tube under constant heat flux

Abstract An experimental investigation has been carried out to study the heat transfer and pressure drop characteristics of nanofluid flow inside horizontal helical tube under constant heat flux. The nanofluid is prepared by dispersion of CuO nanoparticle in base oil and stabilized by means of an ultrasonic device. Nanofluids with different particle weight concentrations of 0.5%, 1% and 2% are used. The effect of different parameters such as flow Reynolds number, fluid temperature and nanofluid particle concentration on heat transfer coefficient and pressure drop of the flow are studied. Observations show that by using the helically coiled tube instead of the straight one, the heat transfer performance is improved. Also, the curvature of the tube will result in the pressure drop enhancement. In addition, the heat transfer coefficient as well as pressure drop is increased by using nanofluid instead of base fluid. Furthermore, the performance evaluation of the two enhanced heat transfer techniques studied in this investigation shows that applying helical tube instead of the straight tube is a more effective way to enhance the convective heat transfer coefficient compared to the second method which is using nanofluids instead of the pure liquid.

[1]  J. Whitelaw,et al.  Convective heat and mass transfer , 1966 .

[2]  Yulong Ding,et al.  Heat transfer of aqueous suspensions of carbon nanotubes (CNT nanofluids) , 2006 .

[3]  J. Buongiorno,et al.  Experimental Investigation of Turbulent Convective Heat Transfer and Pressure Loss of Alumina/Water and Zirconia/Water Nanoparticle Colloids (Nanofluids) in Horizontal Tubes , 2008 .

[4]  R. Chou,et al.  CuO, ZrO2 and ZnO nanoparticles as antiwear additive in oil lubricants , 2008 .

[5]  M. Chandrasekar,et al.  Experimental studies on heat transfer and friction factor characteristics of Al2O3/water nanofluid in a circular pipe under laminar flow with wire coil inserts , 2010 .

[6]  C. T. Nguyen,et al.  New temperature dependent thermal conductivity data for water-based nanofluids , 2009 .

[7]  Huaqing Xie,et al.  Enhancement of thermal conductivity of kerosene-based Fe3O4 nanofluids prepared via phase-transfer method , 2010 .

[8]  Yuh-Yih Wu,et al.  Experimental analysis of tribological properties of lubricating oils with nanoparticle additives , 2007 .

[9]  Yulong Ding,et al.  Experimental investigation into convective heat transfer of nanofluids at the entrance region under laminar flow conditions , 2004 .

[10]  Haisheng Chen,et al.  Heat transfer and flow behaviour of aqueous suspensions of TiO2 nanoparticles (nanofluids) flowing upward through a vertical pipe , 2007 .

[11]  B. Raj,et al.  Effect of clustering on the thermal conductivity of nanofluids , 2008 .

[12]  Y. Xuan,et al.  Investigation on Convective Heat Transfer and Flow Features of Nanofluids , 2003 .

[13]  R. C. Xin,et al.  An experimental study of single-phase and two-phase flow pressure drop in annular helicoidal pipes , 1997 .

[14]  Young I Cho,et al.  HYDRODYNAMIC AND HEAT TRANSFER STUDY OF DISPERSED FLUIDS WITH SUBMICRON METALLIC OXIDE PARTICLES , 1998 .

[15]  G.S.V. Raghavan,et al.  Comparison of heat transfer rates between a straight tube heat exchanger and a helically coiled heat exchanger , 2002 .

[16]  Ravikanth S. Vajjha,et al.  Experimental determination of thermal conductivity of three nanofluids and development of new correlations , 2009 .

[17]  S. Suresh,et al.  Experimental investigations and theoretical determination of thermal conductivity and viscosity of Al2O3/water nanofluid , 2010 .

[18]  M. Esfahany,et al.  Experimental study of turbulent convective heat transfer and pressure drop of dilute CuO/water nanofluid inside a circular tube , 2010 .

[19]  Stephen U. S. Choi.  Enhancing thermal conductivity of fluids with nano-particles , 1995 .