D0-EC RTD Wiring Layout (North Calorimeter)

The temperature of the North End-Calorimeter of the D-Zero detector is to be monitored by several RTD temperature sensors. The location and other important information pertaining to each individual RTD is included in the following tables, which are grouped by bundle number. There are mne 60 pIll port connectors. Each connector corresponds to a bundle of twisted pairs. Twisted pairs, of one of eight colors along with either a black or white wire, run to 10-pin connectors which have a mate on the module or cryostat wall. In general, all 60 pins, or all 10 pins are not used. The color scheme of the wires was designed so that all the twisted pairs with white run West from the instrumentation port, and twisted pairs with black run East. This scheme proved to be very successful and efficient during the installation process. After being installed, every RTD connection was checked and their corresponding resistances were recorded by Jerry Blazey. All the RTD's tested successfully, except for 2. The 2 dead RTD's were: Channel 17 on bundle 4, which is located on the front of MH module 8L; and Channel 13 on bundle 5, which is located on the Bottom of themore » Middle Coarse Plate of the IH.« less