A piezoelectric cantilever with a Helmholtz resonator as a sound pressure sensor

In this paper, a piezoelectric cantilever with a Helmholtz resonator (HR) is proposed as a sound pressure sensor that generates a sufficiently large output voltage at a specific frequency without a power supply to drive the sensing element. A Pb (Zr, Ti) O3 (PZT) cantilever with dimensions of 1500 µm × 1000 µm × 2 µm is designed so that its mechanical resonance frequency agrees with the target frequency. When sound pressure is applied at the target frequency, a large piezoelectric voltage can be obtained due to a high amplification ratio. Additionally, the PZT cantilever is combined with a HR whose resonant frequency is designed to be equal to that of the cantilever. This multiplication of two resonant vibration systems can generate detectable signals by sound pressures of several Pascals. The fabricated sensor generated a piezoelectric voltage of 13.4 mV Pa−1 at the resonant frequency of 2.6 kHz. Furthermore, the fabricated sensor performed as an electrical trigger switch when a sound pressure of 2 Pa was applied at the resonant frequency.

[1]  Takeshi Kobayashi,et al.  A piezoelectric flow sensor for use as a wake-up switch for a wireless sensor network node , 2013 .

[2]  Wei Liang,et al.  Acoustic detection technology for gas pipeline leakage. , 2013 .

[3]  Ryan L. Harne,et al.  A review of the recent research on vibration energy harvesting via bistable systems , 2013 .

[4]  Ming-Chyuan Lu,et al.  Study of high-frequency sound signals for tool wear monitoring in micromilling , 2012 .

[5]  I. Shimoyama,et al.  MEMS microphone with a micro Helmholtz resonator , 2012 .

[6]  Wenbo Lu,et al.  A fault diagnosis scheme of rolling element bearing based on near-field acoustic holography and gray level co-occurrence matrix , 2012 .

[7]  Srinivas Tadigadapa,et al.  Piezoelectric MEMS sensors: state-of-the-art and perspectives , 2009 .

[8]  Ryutaro Maeda,et al.  A fatigue test method for Pb(Zr,Ti)O3 thin films by using MEMS-based self-sensitive piezoelectric microcantilevers , 2008 .

[9]  Paul Muralt,et al.  Recent Progress in Materials Issues for Piezoelectric MEMS , 2008 .

[10]  E. S. Kim,et al.  Single- and Triaxis Piezoelectric-Bimorph Accelerometers , 2008, Journal of Microelectromechanical Systems.

[11]  Ryutaro Maeda,et al.  Effect of multi-coating process on the orientation and microstructure of lead zirconate titanate (PZT) thin films derived by chemical solution deposition , 2005 .

[12]  Janez Kopac,et al.  Tool wear monitoring during the turning process , 2001 .

[13]  Ashraf A. Kassim,et al.  Application of image and sound analysis techniques to monitor the condition of cutting tools , 2000, Pattern Recognit. Lett..

[14]  N. Tandon,et al.  A review of vibration and acoustic measurement methods for the detection of defects in rolling element bearings , 1999 .

[15]  Wouter Olthuis,et al.  A review of silicon microphones , 1994 .

[16]  B. C. Nakra,et al.  Comparison of vibration and acoustic measurement techniques for the condition monitoring of rolling element bearings , 1992 .