Numerically observed shear bands in soft sensitive clays

The numerical challenges that arise in modelling shear bands in soft sensitive (SS) clays have not yet been fully resolved. Convincing and well-accepted solutions have yet to be found. This paper presents some novel information related to the shear band phenomenon in SS clays. In this study, the hypothesis is that the generation and dissipation of excess pore pressure from shear bands could regularise the strain softening and result in a mesh independent shear band thickness. The generation and dissipation of excess pressure is modelled by a coupled consolidation process. The simulation aims at modelling two counteracting mechanisms in the SS clay. First, the shear band narrows because of strain softening. Second, the internal pore water pressure drainage reduces the rate of strain softening. This counteracting mechanism provides an inherent regularisation technique for SS clays. This study presents some numerical results involving these two counteracting mechanisms. This study also shows that an inherent internal parameter applicable for SS clays can be defined by the ratio between soil permeability and the applied strain rate. In the case of SS clays, the range of this parameter varies from 0 to 0.0002 mm.

[1]  H Jostad,et al.  Calculation of shear band thickness in sensitive clays , 2006 .

[2]  J. Chu,et al.  Drained behaviour of Changi sand in triaxial and plane-strain compression , 2007 .

[3]  J. Tejchman.  Influence of a characteristic length on shear zone formation in hypoplasticity with different enhancements , 2004 .

[4]  Poul V. Lade,et al.  Instability, shear banding, and failure in granular materials , 2002 .

[5]  Suched Likitlersuang,et al.  Predictions of a continuous hyperplasticity model for Bangkok clay , 2007 .

[6]  B. Indraratna,et al.  Critical review on shear strength models for soil-infilled joints , 2009 .

[7]  Liqun Liang,et al.  Cracks, bifurcation and shear bands propagation in saturated clays , 1994 .

[8]  F. Molenkamp.  COMPARISON OF FRICTIONAL MATERIAL MODELS WITH RESPECT TO SHEAR BAND INITIATION , 1985 .

[9]  Kenneth Runesson,et al.  Evaluation of Plastic Bifurcation for Plane Strain versus Axisymmetry , 1992 .

[10]  B. Schrefler.  Multiphase flow in deforming porous material , 2004 .

[11]  Erich Bauer,et al.  CALIBRATION OF A COMPREHENSIVE HYPOPLASTIC MODEL FOR GRANULAR MATERIALS , 1996 .

[12]  Ioannis Vardoulakis,et al.  Shear band inclination and shear modulus of sand in biaxial tests , 1980 .

[13]  T. Thomas.  Plastic Flow and Fracture in Solids , 1958 .

[14]  R. Hill.  A general theory of uniqueness and stability in elastic-plastic solids , 1958 .

[15]  Fernando Schnaid,et al.  A critical state framework for modelling bonded geomaterials , 2007 .

[16]  L. Andresen,et al.  Analyses of progressive failure in long natural slopes , 2004 .

[17]  Stig Bernander,et al.  Progressive landslides in long natural slopes : formation, potential extension and configuration of finished slides in strain-softening soils , 2011 .

[18]  G. Gudehus.  A COMPREHENSIVE CONSTITUTIVE EQUATION FOR GRANULAR MATERIALS , 1996 .

[19]  Jacek Tejchman,et al.  FE-studies on the influence of initial void ratio, pressure level and mean grain diameter on shear localization , 1999 .

[20]  J. Rice,et al.  A note on some features of the theory of localization of deformation , 1980 .

[21]  R. Hill.  Acceleration waves in solids , 1962 .

[22]  J. Chu,et al.  Undrained behaviour of Changi sand in triaxial and plane-strain compression , 2008 .

[23]  J. Bardet.  FINITE ELEMENT ANALYSIS OF PLANE STRAIN BIFURCATION WITHIN COMPRESSIBLE SOLIDS , 1990 .

[24]  S. Nemat-Nasser,et al.  Experimental Micromechanical Evaluation of the Strength of Granular Materials: Effects of Particle Rolling , 1983 .

[25]  J. Rice.  Localization of plastic deformation , 1976 .