Abstract Flutter testing is aimed at demonstrating that the aircraft flight envelope is flutter free. Response measurements from deliberate excitation of the structure are used to identify and track frequency and damping values against velocity. In this paper, the common approach of using a flight control surface to provide the excitation is examined using a mathematical model of a wing and control surface whose rotation is restrained by a simple actuator. In particular, it is shown that it is essential to use the demand signal to the actuator as a reference signal for data processing. Use of the actuator force (or strain) or control angle (or actuator displacement) as a reference signal is bad practice because these signals contain response information. It may also be dangerous in that the onset of flutter may not be seen in the test results.
[1]
J. W. G. van Nunen,et al.
AGARD Flight Test Instrumentation Series. Volume 9. Aeroelastic Flight Test Techniques and Instrumentation
,
1979
.
[2]
Robert H. Scanlan,et al.
Introduction to the study of aircraft vibration and flutter
,
1952,
The Journal of the Royal Aeronautical Society.
[3]
I. Abel,et al.
Application of a flight test and data analysis technique to flutter of a drone aircraft
,
1981
.
[4]
Mark Richardson,et al.
PARAMETER ESTIMATION FROM FREQUENCY RESPONSE MEASUREMENTS USING RATIONAL FRACTION POLYNOMIALS (TWENTY YEARS OF PROGRESS)
,
1982
.
[5]
G. J. Hancock,et al.
On the teaching of the principles of wing flexure-torsion flutter
,
1985
.