Location and catalytic role of iron species in TiO2:Fe photocatalysts: An EPR study

Abstract A usual approach to improve the photocatalytic activity of wide band gap oxide semiconductors is through doping with transition metals. Dopants are primarily selected according to their capacity to introduce energy levels in the oxide band gap, promoting light absorbance. In the present work, we carefully characterize iron-doped titania powders obtained by a sol–gel route. Iron cations are introduced in the initial solution, before gelification, what promotes their lattice localization. X-ray diffraction and electron spin resonance spectroscopy are used to determine the temperature evolution of the crystalline structure and the dopant local environment. These results allow us to correlate the structural, electronic and chemical properties of the iron-doped titania powders with their activity towards the photocatalytic degradation of methylene blue (MB). The obtained results showed that Fe 3+ cations far from improve the photocatalytic properties of bare TiO 2 , decreased the activity towards methylene blue degradation. We associated such decrease with the role played by the iron cations depending on their position inside the lattice of TiO 2 . And second, iron cations located near or at the surface tend to form iron-based structures, such as iron titanate or pseudobrookite which are highly inactive as photocatalyst.

[1]  Jinlong Zhang,et al.  Characterization of Fe–TiO2 photocatalysts synthesized by hydrothermal method and their photocatalytic reactivity for photodegradation of XRG dye diluted in water , 2004 .

[2]  Akira Fujishima,et al.  Titanium dioxide photocatalysis , 2000 .

[3]  Marta I. Litter,et al.  Photocatalytic properties of iron-doped titania semiconductors , 1996 .

[4]  Ulrike Diebold,et al.  The surface science of titanium dioxide , 2003 .

[5]  J. Herrmann,et al.  Photocatalytic degradation pathway of methylene blue in water , 2001 .

[6]  Brown,et al.  Surface Precipitation of Co(II)(aq) on Al2O3 , 1997, Journal of colloid and interface science.

[7]  J. Thorp,et al.  Rhombic symmetry sites in Fe/TiO2 powders , 1985 .

[8]  M. Fernández-García,et al.  Structure and activity of nanosized iron-doped anatase TiO2 catalysts for phenol photocatalytic degradation , 2007 .

[9]  Shigeyasu Kuroda,et al.  Comparative assessment of the efficiency of Fe-doped TiO2 prepared by two doping methods and photocatalytic degradation of phenol in domestic water suspensions , 2007 .

[10]  Joan Ramon Morante,et al.  Influence of the catalytic introduction procedure on the nano-SnO2 gas sensor performances , 2001 .

[11]  S. Martin,et al.  Environmental Applications of Semiconductor Photocatalysis , 1995 .

[12]  M. Flytzani-Stephanopoulos,et al.  Cu- and Ag-Modified Cerium Oxide Catalysts for Methane Oxidation , 1998 .

[13]  J. Evans,et al.  An electron spin resonance study of rutile and anatase titanium dioxide polycrystalline powders treated with transition-metal ions , 1987 .

[14]  B. Viswanathan,et al.  Photocatalytic reduction of nitrite and nitrate ions to ammonia on M/TiO2 catalysts , 1997 .

[15]  X. Doménech,et al.  Heterogeneous photocatalytic reactions of nitrite oxidation and Cr(VI) reduction on iron-doped titania prepared by the wet impregnation method , 1998 .

[16]  Jiaguo Yu,et al.  Effects of Fe-doping on the photocatalytic activity of mesoporous TiO2 powders prepared by an ultrasonic method. , 2006, Journal of hazardous materials.

[17]  G. Colón,et al.  Iron-doped titania semiconductor powders prepared by a sol-gel method. Part I : Synthesis and characterization , 1999 .

[18]  G. Córdoba,et al.  Influence of manganese ions on the anatase–rutile phase transition of TiO2 prepared by the sol–gel process , 2002 .

[19]  J. M. Coronado,et al.  Photocatalytic Inactivation of Legionella Pneumophila and an Aerobic Bacteria Consortium in Water over TiO2/SiO2 Fibres in a Continuous Reactor , 2005 .

[20]  R. Aasa.  Powder Line Shapes in the Electron Paramagnetic Resonance Spectra of High‐Spin Ferric Complexes , 1970 .

[21]  J. A. Pask,et al.  Kinetics of the Anatase‐Rutile Transformation , 1965 .

[22]  Xinyong Li,et al.  Synthesis and photocatalytic oxidation properties of iron doped titanium dioxide nanosemiconductor particles , 2003 .

[23]  C. Rowlands,et al.  An EPR study of diffusion of iron into rutile , 2001 .

[24]  Udo Weimar,et al.  Influence on the gas sensor performances of the metal chemical states introduced by impregnation of calcinated SnO2 sol–gel nanocrystals , 2000 .

[25]  K. Asai,et al.  Analysis of electronic structures of 3d transition metal-doped TiO 2 based on band calculations , 2002 .

[26]  Javier Soria,et al.  Dinitrogen photoreduction to ammonia over titanium dioxide powders doped with ferric ions , 1991 .

[27]  Bonamali Pal,et al.  Preparation and characterization of TiO2/Fe2O3 binary mixed oxides and its photocatalytic properties , 1999 .

[28]  R. S. Biasi,et al.  Measurement of small concentrations of chromium and iron in rutile (TiO2) using electron spin resonance , 1993 .

[29]  Jinlong Zhang,et al.  Fe3+-TiO2 photocatalysts prepared by combining sol-gel method with hydrothermal treatment and their characterization , 2006 .

[30]  Jackie Y. Ying,et al.  Role of Particle Size in Nanocrystalline TiO2-Based Photocatalysts , 1998 .

[31]  J. Fierro,et al.  Catalytic Combustion of Methane on Fe-TiO2 Catalysts Prepared by Sol-Gel Method , 2003 .

[32]  V. Rives,et al.  Surface structure and reactivity of molybdena–titania catalysts prepared by different methods , 1993 .

[33]  Joan Ramon Morante,et al.  Study of La and Cu influence on the growth inhibition and phase transformation of nano-TiO2 used for gas sensors , 2004 .

[34]  Kengo Shimanoe,et al.  Cr-doped TiO2 gas sensor for exhaust NO2 monitoring , 2003 .