Three-dimensional CFD simulation of Geyser boiling in a two-phase closed thermosyphon

[1]  Hussam Jouhara,et al.  CFD modelling of a two-phase closed thermosyphon charged with R134a and R404a , 2015 .

[2]  Xuewu Cao,et al.  Visualization experiments on the geyser boiling-induced instability in vertical circular tube at low-pressures , 2015 .

[3]  Abdul-Ghani Olabi,et al.  100% sustainable energy , 2014 .

[4]  Yuzhu Liu,et al.  Role of heat pipes in improving the hydrogen charging rate in a metal hydride storage tank , 2014 .

[5]  Ali Turan,et al.  Simulation of the response of a thermosyphon under pulsed heat input conditions , 2014 .

[6]  K. Lo,et al.  Improving temperature uniformity and performance of CO preferential oxidation for hydrogen-rich reformate with a heat pipe , 2014 .

[7]  Hussam Jouhara,et al.  Thermal performance characteristics of a wraparound loop heat pipe (WLHP) charged with R134A , 2013 .

[8]  Hussam Jouhara,et al.  Numerical modelling of the temperature distribution in a two-phase closed thermosyphon , 2013 .

[9]  Chien-Yuh Yang,et al.  Experimental study on the hydrogen charge and discharge rates of metal hydride tanks using heat pipes to enhance heat transfer , 2013 .

[10]  Zirong Lin,et al.  Simulation of a miniature oscillating heat pipe in bottom heating mode using CFD with unsteady modeling , 2013 .

[11]  B. Hardy,et al.  Optimization of internal heat exchangers for hydrogen storage tanks utilizing metal hydrides , 2012 .

[12]  Kevin Kerrigan,et al.  Heat pipe-based radiator for low grade geothermal energy conversion in domestic space heating , 2011, Simul. Model. Pract. Theory.

[13]  Velraj Ramalingam,et al.  Experimental investigation and CFD analysis of a air cooled condenser heat pipe , 2011 .

[14]  Hussam Jouhara,et al.  Experimental investigation of wraparound loop heat pipe heat exchanger used in energy efficient air handling units , 2010 .

[15]  Abdul-Ghani Olabi,et al.  The 3rd international conference on sustainable energy and environmental protection SEEP 2009-Guest Editor's Introduction , 2010 .

[16]  Reza Hosseini,et al.  Experimental investigation of effective parameters and correlation of geyser boiling in a two-phase closed thermosyphon , 2010 .

[17]  O. Zikanov.  Essential Computational Fluid Dynamics , 2010 .

[18]  W. Srimuang,et al.  Comparative heat transfer characteristics of a flat two-phase closed thermosyphon (FTPCT) and a conventional two-phase closed thermosyphon (CTPCT) , 2010 .

[19]  Masoud Rahimi,et al.  CFD modeling of flow and heat transfer in a thermosyphon , 2010 .

[20]  Anthony J. Robinson,et al.  Experimental investigation of small diameter two-phase closed thermosyphons charged with water, FC-84, FC-77 and FC-3283 , 2010 .

[21]  A. Robinson,et al.  An Experimental Study of Small-Diameter Wickless Heat Pipes Operating in the Temperature Range 200°C to 450°C , 2009 .

[22]  Guoyuan Ma,et al.  Numerical simulation and experimental verification of a flat two-phase thermosyphon , 2009 .

[23]  Limin Qiu,et al.  Investigation on the effect of filling ratio on the steady-state heat transfer performance of a vertical two-phase closed thermosyphon , 2008 .

[24]  V. A. Babenko,et al.  Hydrogen storage system based on novel carbon materials and heat pipe heat exchanger , 2007 .

[25]  M. Hirscher,et al.  Metal hydride materials for solid hydrogen storage: a review , 2007 .

[26]  Leonard L. Vasiliev,et al.  Heat pipes in modern heat exchangers , 2005 .

[27]  T. Oi,et al.  Heat transfer characteristics of the metal hydride vessel based on the plate-fin type heat exchanger , 2004 .

[28]  K. S. Ong,et al.  Performance of a R-134a-filled thermosyphon , 2003 .

[29]  S. B. Nasrallah,et al.  Heat and mass transfer models in metal-hydrogen reactor , 1997 .

[30]  Tsing-Fa Lin,et al.  Experimental investigation of geyser boiling in an annular two-phase closed thermosyphon , 1996 .

[31]  J. Anderson,et al.  Computational fluid dynamics : the basics with applications , 1995 .

[32]  J. Brackbill,et al.  A continuum method for modeling surface tension , 1992 .

[33]  Manfred Groll,et al.  Heat and mass transfer in metal hydride reaction beds: Experimental and theoretical results , 1987 .

[34]  Teruo Sawada,et al.  Heat transfer performance of an inclined two-phase closed thermosyphon , 1983 .