Improved mechanical models and Ic estimation for the whole life cycle of high temperature superconducting coated conductors
暂无分享,去创建一个
L. Ren | Ying Xu | Yuejin Tang | Xianhao Li
[1] J. Sheng,et al. Numerical Study on Mechanical Properties of Conductors on Round Core Cables , 2021, IEEE Transactions on Applied Superconductivity.
[2] Yi-fan Wang,et al. Bending and uniaxial tensile strain effects on the critical current of REBCO coated conductor tapes , 2021, Cryogenics.
[3] Youhe Zhou,et al. Nonlinear contact behavior of HTS tapes during pancake coiling and CORC cabling , 2021, Superconductor Science and Technology.
[4] Yinshun Wang,et al. Strain analysis and bending properties of quasi-isotropic superconducting strand based on laminate theory , 2021 .
[5] W. T. B. de Sousa,et al. An open-source 2D finite difference based transient electro-thermal simulation model for three-phase concentric superconducting power cables , 2020, Superconductor Science and Technology.
[6] B. Li,et al. Current limiting tests of a prototype 160 kV/1 kA resistive DC superconducting fault current limiter , 2020, Superconductor Science and Technology.
[7] I. Das,et al. Structural Analysis of 2G HTS Tapes under Different Loading Conditions for HTS Power Cable using Finite Element Modeling , 2020 .
[8] Youhe Zhou,et al. Stress, strain and electromechanical analyses of (RE)Ba2Cu3Ox conductors using three-dimensional/two-dimensional mixed-dimensional modeling: fabrication, cooling and tensile behavior , 2020, Superconductor Science and Technology.
[9] W. Yuan,et al. Quench behavior of high-temperature superconductor (RE)Ba2Cu3Ox CORC cable , 2019, Journal of Physics D: Applied Physics.
[10] Yuanwen Gao,et al. Three-dimensional multifilament finite element models of Bi-2212 high-temperature superconducting round wire under axial load , 2019, Composite Structures.
[11] D. McRae,et al. Status of CORC® cables and wires for use in high-field magnets and power systems a decade after their introduction , 2019, Superconductor Science and Technology.
[12] R. J. Thomas,et al. Bending of CORC® cables and wires: finite element parametric study and experimental validation , 2018, Superconductor Science and Technology.
[13] Yuanwen Gao,et al. The winding mechanical behavior of conductor on round core cables , 2018, Physica C: Superconductivity and its Applications.
[14] Xingzhe Wang,et al. Mixed-dimensional modeling of delamination in rare earth-barium-copper-oxide coated conductors composed of laminated high-aspect-ratio thin films , 2018, Superconductor Science and Technology.
[15] Xingzhe Wang,et al. Analysis of torsional deformation-induced degeneration of critical current of Bi-2223 HTS composite tapes , 2018, International Journal of Mechanical Sciences.
[16] Yuanwen Gao,et al. Numerical simulation of the electro-thermo-mechanical behaviors of a high-temperature superconducting cable , 2018 .
[17] Y. Yanagisawa,et al. Degradation of the performance of an epoxy-impregnated REBCO solenoid due to electromagnetic forces , 2018 .
[18] Yuanwen Gao,et al. Numerical models of delamination behavior in 2G HTS tapes under transverse tension and peel , 2018 .
[19] T. Takao,et al. Degradation of a REBCO conductor due to an axial tensile stress under edgewise bending: a major stress mode of deterioration in a high field REBCO coil’s performance , 2017 .
[20] Li Ren,et al. A Study on the Design and Comparison of 1–100-MJ-Class SMES Magnet With Different Coil Configurations , 2017, IEEE Transactions on Applied Superconductivity.
[21] Tao Tang,et al. Development of 35 kV 2000 A CD HTS Cable Demonstration Project , 2016, IEEE Transactions on Applied Superconductivity.
[22] K. Hayashi,et al. Construction and the Circulation Test of the 500-m and 1000-m DC Superconducting Power Cables in Ishikari , 2016, IEEE Transactions on Applied Superconductivity.
[23] Y. Zhang,et al. Stress–Strain Relationship, Critical Strain (Stress) and Irreversible Strain (Stress) of IBAD-MOCVD-Based 2G HTS Wires Under Uniaxial Tension , 2016, IEEE Transactions on Applied Superconductivity.
[24] T. Takao,et al. Degradation of a REBCO Coil Due to Cleavage and Peeling Originating From an Electromagnetic Force , 2016, IEEE Transactions on Applied Superconductivity.
[25] Arend Nijhuis,et al. Experiments and FE modeling of stress–strain state in ReBCO tape under tensile, torsional and transverse load , 2015 .
[26] C. Senatore,et al. Progresses and challenges in the development of high-field solenoidal magnets based on RE123 coated conductors , 2014, Superconductor science & technology.
[27] J. Dizon,et al. Analysis of Thermal Residual Stress/Strain in REBCO Coated Conductor Tapes , 2014, IEEE Transactions on Applied Superconductivity.
[28] Sanghan Lee,et al. Development and production of second generation high Tc superconducting tapes at SuperOx and first tests of model cables , 2014 .
[29] W. Chen,et al. Numerical Studies of Thermally Induced Residual Strain/Stress in Bi2Sr2Ca2Cu3Ox/Ag/Ag Alloy Composite Tapes and the Dependence of Material Properties on the Temperature , 2014 .
[30] M. Takayasu,et al. Electromechanical Investigation of Different Type YBCO Tapes for Twisted Stacked-Tape Cabling , 2013, IEEE Transactions on Applied Superconductivity.
[31] A. Ballarino,et al. Analytical Formulation of $I_{c}$ Dependence on Torsion of YBCO and BSCCO Conductors , 2013, IEEE Transactions on Applied Superconductivity.
[32] Honghai Song,et al. On the role of pre-existing defects and magnetic flux avalanches in the degradation of YBa2Cu3O7–x coated conductors by quenching , 2012 .
[33] S. Nagaya,et al. Bending strain analysis considering a shift of the neutral axis for YBCO coated conductors with and without a Cu stabilizing layer , 2011 .
[34] J. Lim,et al. Progress on the Performance Test of KEPCO HTS Power Cable , 2011, IEEE Transactions on Applied Superconductivity.
[35] J F Maguire,et al. Progress and Status of a 2G HTS Power Cable to Be Installed in the Long Island Power Authority (LIPA) Grid , 2011, IEEE Transactions on Applied Superconductivity.
[36] Joseph V. Minervini,et al. HTS twisted stacked-tape cable conductor , 2011 .
[37] Loren F. Goodrich,et al. High-current dc power transmission in flexible RE–Ba2Cu3O7 − δ coated conductor cables , 2011 .
[38] Woo-Seok Kim,et al. Joint Characteristics of the YBCO Coated Conductor (CC) by Chemical Etching , 2009, IEEE Transactions on Applied Superconductivity.
[39] H. Adachi,et al. Internal residual strain and critical current maximum of a surrounded Cu stabilized YBCO coated conductor , 2009 .
[40] H. Shin,et al. Effect of Bending Test Procedure on the Degradation Behavior of Critical Current in ReBCO Coated Conductor Tapes , 2009 .
[41] M. Paranthaman,et al. Analytical modeling of residual stresses in multilayered superconductor systems , 2008, Journal of Materials Science.
[42] N. Ayai,et al. Mechanical behavior and strain dependence of the critical current of DI-BSCCO tapes , 2008 .
[43] V. E. Sytnikov,et al. 1G versus 2G-comparison from the practical standpoint for HTS power cables use , 2008 .
[44] A. Otto,et al. Thermally induced residual strain accumulation in Bi2223/Ag/Ag alloy composite superconductor , 2007 .
[45] S. Nagaya,et al. Development of long YBCO coated conductors by multiple-stage CVD , 2006 .
[46] W. Prusseit,et al. Tensile fracture behaviour of RE-123 coated conductors induced by discontinuous yielding in Hastelloy C-276 substrate , 2005 .
[47] W. Prusseit,et al. Intrinsic strain effect on critical current and its reversibility for YBCO coated conductors with different buffer layers , 2005 .
[48] M. Paranthaman,et al. The RABiTS Approach: Using Rolling-Assisted Biaxially Textured Substrates for High-Performance YBCO Superconductors , 2004 .
[49] J. P. Singh,et al. Influence of processing methods on residual stress evolution in coated conductors , 2004 .
[50] Timothy A. Brunner,et al. Elastic relationships in layered composite media with approximation for the case of thin films on a thick substrate , 1987 .
[51] J. Ekin. Strain Effects in Superconducting Compounds , 1984 .