Effect of microstructure on the sliding wear performance of a Zn–Al–Ni alloy

Abstract Some observations pertaining to the sliding wear characteristics of a zinc–aluminium alloy containing nickel under varying material and test conditions have been reported in this investigation. Dry sliding wear tests were conducted on as-cast and heat-treated zinc-based alloy pins using a pin-on-disc machine. A steel disc was employed as the counterface. Sliding speeds adopted were 0.42, 2.68 and 4.60 m/s while the traversal distance was fixed at 500 m. Wear tests were conducted at different pressures using separate pins in each case. Seizure pressure of the pins (prior to traversing the sliding distance of 500 m) was determined at each speed. Wear rate and the extent of frictional heating increased with pressure and speed whereas seizure pressure practically followed a reverse trend. The wear rate versus pressure plot of the as-cast alloy pins assumed two slopes at the lowest speed wherein low slope (indicating the occurrence of mild wear situation) was noticed initially. This was followed by the attainment of a higher slope suggesting severe wear condition at increased pressures. At higher speeds, one slope only (identical to the higher slope at the minimum speed) was noted. Wear rate versus pressure plots of the heat-treated alloy pins followed a trend similar to the as-cast ones except that two slopes were noted up to the intermediate speed in the former case. Heat treatment changed the as-cast dendritic structure of the zinc-based alloy into the one with an improved uniformity of the distribution of various microconstituents, the nickel containing phase remaining practically unaffected. Softening of the (as-cast) alloy was also observed as a result of the heat treatment. However, in spite of reduced hardness, the heat-treated alloy pins attained improved wear behaviour (i.e. reduced frictional heating and low wear rate) over the as-cast ones irrespective of the test conditions. This was attributed to a more uniform distribution of microconstituents and reduced cracking tendency of the alloy as a result of the heat treatment. The alloy pins also attained better seizure pressure in heat-treated condition comparing with the as-cast ones at all the speeds except the maximum for the same reasons. A reversal in the trend at the maximum speed was thought to be due to the over-softening of the already softened (heat-treated) alloy pins under the influence of large frictional heat generated at the (maximum) speed. Under the circumstances, the heat-treated alloy pins tended to adhere/fuse with the disc extensively while this tendency was relatively less for the as-cast ones in view of their higher hardness. Further, the extent of the negative influence of cracking tendency reduced allowing thermal stability to predominate the wear behaviour of the as-cast alloy pins in this case. The factor led to somewhat higher seizure pressure of the (as-cast) alloy pins at the maximum speed comparing with the heat-treated ones. Low wear rates correlated with less damage to the worn surfaces and to the regions below the worn surfaces and finer debris formation. Seizure led to severe damage to the worn surfaces and to the regions below the worn surfaces while the debris formed was quite bulky and coarser.