System Simulations to Evaluate the Potential Efficiency of Humid Air Motors

In the quest for efficiency improvement in heavy duty truck engines, waste heat recovery could play a valuable role. The evaporative cycle is a waste heat recovery technology aimed at improving efficiency and decreasing emissions. A humid air motor (HAM) uses the waste heat from the exhaust of the engine to humidify the inlet air; this humid air, with higher specific heat, reduces NOx emission to a greater extent [1] [2]. Despite this benefit of emission reduction, the increase or decrease in efficiency of the humid air motor compared to the conventional engine is not discussed in the literature [3] [4] [5]. In this paper, an attempt is made to study the efficiency of the HAM using system model simulations of a 13-liter heavy duty Volvo engine with a humidifier. The commercial software GT-SUITE is used to build the system model and to perform the simulations. The efficiency improvement of the HAM comes from the expansion of the vapor mass flow produced as a result of humidification. An effort is also made to understand the relationship between the humidified engine and its efficiency. (Less)

[1]  P. F. Flynn,et al.  Development of a Single Cylinder Compression Ignition Research Engine , 1965 .

[2]  Koji Yoshida,et al.  Study on Performance of Diesel Engine Applied with Emulsified Diesel Fuel: The Influence of Fuel Injection Timing and Water Contents , 2011 .

[3]  Ehsan Shamloo,et al.  Investigation of the Effect of a Humid Air System on Diesel NOx and PM Emissions of a Small Diesel Engine , 2011 .

[4]  P. Dittrich,et al.  Effects of Direct Water Injection on DI Diesel Engine Combustion , 2000 .

[5]  Humidification tower for humid air gas turbine cycles: Experimental analysis , 2010 .

[6]  R. Udayakumar,et al.  Reduction of NOx Emissions by Water Injection in to the Inlet Manifold of a DI Diesel Engine , 2003 .

[7]  Hyoung-Keun Park,et al.  A Study on NO x Reduction of Marine 4-Stroke Diesel Engine Using Charge Air Humidification , 2011 .

[8]  Dan Haupt,et al.  Particles And Emissions from a Diesel Engine Equipped with a Humid Air Motor System , 2001 .

[9]  Noboru Miyamoto,et al.  Expansion of the Operating Range with In-Cylinder Water Injection in a Premixed Charge Compression Ignition Engine , 2002 .

[10]  Michael A. Boles,et al.  Thermodynamics : An Engineering Approach, 7th Edition , 2009 .

[11]  Marouan A. A. Nazha,et al.  The Use of Emulsion, Water Induction and EGR for Controlling Diesel Engine Emissions , 2001 .

[12]  G. C. Mavropoulos,et al.  Comparative Evaluation of EGR, Intake Water Injection and Fuel/Water Emulsion as NOx Reduction Techniques for Heavy Duty Diesel Engines , 2007 .

[13]  Meiping Wang,et al.  Effects of Intake Air Humidity on the NOX Emissions and Performance of a Light-Duty Diesel Engine , 2012 .

[14]  G. Woschni.  A Universally Applicable Equation for the Instantaneous Heat Transfer Coefficient in the Internal Combustion Engine , 1967 .