Engine-integrated solid oxide fuel cells for efficient electrical power generation on aircraft

Abstract This work investigates the use of engine-integrated catalytic partial oxidation (CPOx) reactors and solid oxide fuel cells (SOFCs) to reduce fuel burn in vehicles with large electrical loads like sensor-laden unmanned air vehicles. Thermodynamic models of SOFCs, CPOx reactors, and three gas turbine (GT) engine types (turbojet, combined exhaust turbofan, separate exhaust turbofan) are developed and checked against relevant data and source material. Fuel efficiency is increased by 4% and 8% in the 50 kW and 90 kW separate exhaust turbofan systems respectively at only modest cost in specific power (8% and 13% reductions respectively). Similar results are achieved in other engine types. An additional benefit of hybridization is the ability to provide more electric power (factors of 3 or more in some cases) than generator-based systems before encountering turbine inlet temperature limits. A sensitivity analysis shows that the most important parameters affecting the system's performance are operating voltage, percent fuel oxidation, and SOFC assembly air flows. Taken together, this study shows that it is possible to create a GT-SOFC hybrid where the GT mitigates balance of plant losses and the SOFC raises overall system efficiency. The result is a synergistic system with better overall performance than stand-alone components.

[1]  H. Iwai,et al.  Comprehensive Numerical Modeling and Analysis of a Cell-Based Indirect Internal Reforming Tubular SOFC , 2006 .

[2]  Joshua E. Freeh,et al.  Development of Parametric Mass and Volume Models for an Aerospace SOFC/Gas Turbine Hybrid System , 2005 .

[3]  Massimo Santarelli,et al.  Solid oxide fuel based auxiliary power unit for regional jets: Design and mission simulation with different cell geometries , 2010 .

[4]  Aristide F. Massardo,et al.  Design and part-load performance of a hybrid system based on a solid oxide fuel cell reactor and a micro gas turbine , 2001 .

[5]  James F. Miller,et al.  Key challenges and recent progress in batteries, fuel cells, and hydrogen storage for clean energy systems , 2006 .

[6]  Stuart W. Churchill,et al.  A general expression for the correlation of rates of transfer and other phenomena , 1972 .

[7]  P. G. Batterton.  Energy efficient engine program contributions to aircraft fuel conservation , 1984 .

[8]  D. Brett,et al.  Solid oxide fuel cell/gas turbine hybrid system analysis for high-altitude long-endurance unmanned aerial vehicles , 2008 .

[9]  Joshua E. Freeh,et al.  Solid Oxide Fuel Cell/Gas Turbine Hybrid Cycle Technology for Auxiliary Aerospace Power , 2005 .

[10]  Francesco Calise,et al.  Single-level optimization of a hybrid SOFC-GT power plant , 2006 .

[11]  Robert J. Kee,et al.  Thermodynamics of SOFC efficiency and fuel utilization as functions of fuel mixtures and operating conditions , 2006 .

[12]  E. Onat,et al.  A method to estimate weight and dimensions of large and small gas turbine engines , 1979 .

[13]  V. Sundararajan,et al.  Preliminary Estimation of Engine Gas-Flow-Path Size and Weight , 1998 .

[14]  J. Richardson,et al.  Properties of ceramic foam catalyst supports: one-dimensional and two-dimensional heat transfer correlations , 2004 .

[15]  Lars Sjunnesson,et al.  Combined solid oxide fuel cell and gas turbine systems for efficient power and heat generation , 2000 .

[16]  H. Chandra,et al.  Application of solid oxide fuel cell technology for power generation—A review , 2013 .

[17]  D. Daggett,et al.  Solid Oxide Fuel Cell/Gas Turbine Hybrid APU System for Aerospace Applications , 2006, Conference Record of the 2006 IEEE Industry Applications Conference Forty-First IAS Annual Meeting.

[18]  R. Kee,et al.  The influence of current collection on the performance of tubular anode-supported SOFC cells , 2007 .

[19]  S. Deevi,et al.  Development of interconnect materials for solid oxide fuel cells , 2003 .

[20]  Ian Moir,et al.  Aircraft Systems: Mechanical, Electrical, and Avionics Subsystems Integration , 2008 .

[21]  Zhenhua Jiang,et al.  Multidisciplinary modeling and simulation of a fuel cell/gas turbine hybrid power system , 2009, 2009 IEEE Power & Energy Society General Meeting.

[22]  Jacob Brouwer,et al.  Development of a Solid-Oxide Fuel Cell/Gas Turbine Hybrid System Model for Aerospace Applications , 2004 .

[23]  R. Metkemeijer,et al.  PEMFC application for aviation: Experimental and numerical study of sensitivity to altitude , 2012 .

[24]  Ronald D. Flack.  Fundamentals of Jet Propulsion with Applications , 2005 .

[25]  R. Kee,et al.  Modeling Distributed Charge-Transfer Processes in SOFC Membrane Electrode Assemblies , 2008 .

[26]  M. Yovanovich,et al.  Laminar Forced Convection Heat Transfer in the Combined Entry Region of Non-Circular Ducts , 2004 .

[27]  Jack D. Mattingly,et al.  Elements of Propulsion: Gas Turbines and Rockets , 1996 .

[28]  Martyn V. Twigg,et al.  Fundamentals and applications of structured ceramic foam catalysts , 2007 .

[29]  Nigel P. Brandon,et al.  Optimal integration strategies for a syngas fuelled SOFC and gas turbine hybrid , 2011 .

[30]  Joshua E. Freeh,et al.  Hybrid Solid Oxide Fuel Cell/Gas Turbine System Design for High Altitude Long Endurance Aerospace Missions , 2013 .

[31]  S. Ergun,et al.  Fluid Flow through Randomly Packed Columns and Fluidized Beds , 1949 .

[32]  Steven A. Brandt,et al.  Introduction to Aeronautics: A Design Perspective , 1997 .

[33]  Daniel P. Raymer,et al.  Aircraft Design: A Conceptual Approach , 1989 .

[34]  Martin E. Eshelby.  Aircraft Performance: Theory and Practice , 2000 .

[35]  M. Twigg,et al.  Theory and applications of ceramic foam catalysts , 2002 .

[36]  J. Bear.  Dynamics of Fluids in Porous Media , 1975 .

[37]  G. Naterer,et al.  Thermodynamic modeling of a gas turbine cycle combined with a solid oxide fuel cell , 2008 .

[38]  Frank P. Incropera,et al.  Fundamentals of Heat and Mass Transfer , 1981 .

[39]  H. Ho,et al.  Modelling of simple hybrid solid oxide fuel cell and gas turbine power plant , 2002 .

[40]  R. Herbin,et al.  Three-dimensional numerical simulation for various geometries of solid oxide fuel cells , 1996 .

[41]  J. Richardson,et al.  Properties of ceramic foam catalyst supports: mass and heat transfer , 2003 .

[42]  M. M. Yovanovich,et al.  Pressure Drop in Laminar Developing Flow in Noncircular Ducts: A Scaling and Modeling Approach detailed review and analysis of the hydrodynamic characteristics of laminar developing , 2009 .

[43]  C. R. Peterson,et al.  Mechanics And Thermodynamics Of Propulsion , 1965 .

[44]  Joshua E. Freeh,et al.  Off-Design Performance Analysis of a Solid-Oxide Fuel Cell/Gas Turbine Hybrid for Auxiliary Aerospace Power , 2005 .

[45]  C. Edward Lan,et al.  Airplane Aerodynamics and Performance , 2016 .

[46]  Tak-Hyoung Lim,et al.  Operating characteristics of a 5 kW class anode-supported planar SOFC stack for a fuel cell/gas turbine hybrid system , 2008 .

[47]  Robert J. Kee,et al.  Solid-oxide fuel cells with hydrocarbon fuels , 2005 .

[48]  Dennis L. Huff,et al.  Review of Propulsion Technologies for N+3 Subsonic Vehicle Concepts , 2011 .

[49]  David E. Gray,et al.  Results of NASA's Energy Efficient Engine Program , 1987 .

[50]  James St. Peter.  The History of Aircraft Gas Turbine Engine Development in the United States: A Tradition of Excellence , 2000 .

[51]  Vinod M. Janardhanan,et al.  Modeling Elementary Heterogeneous Chemistry and Electrochemistry in Solid-Oxide Fuel Cells , 2005 .

[52]  J. Islas,et al.  The Gas Turbine , 1999 .

[53]  Robert J. Braun,et al.  System Architectures for Solid Oxide Fuel Cell-Based Auxiliary Power Units in Future Commercial Aircraft Applications , 2009 .

[54]  Alan S. Fung,et al.  Effects of operating and design parameters on the performance of a solid oxide fuel cell–gas turbine system , 2011 .

[55]  E. A. Mason,et al.  Gas Transport in Porous Media: The Dusty-Gas Model , 1983 .

[56]  Angelo Moreno,et al.  Simulation model of a molten carbonate fuel cell–microturbine hybrid system , 2011 .

[57]  R. Kee,et al.  A general mathematical model for analyzing the performance of fuel-cell membrane-electrode assemblies , 2003 .

[58]  Robert J. Kee,et al.  Solid Oxide Fuel Cells: Operating Principles, Current Challenges, and the Role of Syngas , 2008 .