Digitally Controlled Current-Mode DC–DC Converter IC

The main focus of this paper is the implementation of mixed-signal peak current mode control in low-power dc-dc converters for portable applications. A DAC is used to link the digital voltage loop compensator to the analog peak current mode loop. Conventional DAC architectures, such as flash or ΔΣ are not suitable due to excessive power consumption and limited bandwidth of the reconstruction filter, respectively. The charge-pump based DAC (CP-DAC) used in this work has relatively poor linearity compared to more expensive DAC topologies; however, this can be tolerated since the linearity has a minor effect on the converter dynamics as long as the limit-cycle conditions are met. The CP-DAC has a guaranteed monotonic behavior from the digital current command to the peak inductor current, which is essential for maintaining stability. A buck converter IC, which was fabricated in a 0.18 μm CMOS process with 5 V compatible transistors, achieves a response time of 4 μs at fs=3 MHz and Vout=1 V, for a 200 mA load-step. The active area of the controller is only 0.077 mm2, and the total controller current-draw, which is heavily dominated by the on-chip senseFET current-sensor, is below 250 μA for a load current of Iout=50 mA.

[1]  S. Saggini,et al.  An innovative digital control architecture for low-Voltage, high-current DC-DC converters with tight voltage regulation , 2004, IEEE Transactions on Power Electronics.

[2]  C.A.T. Salama,et al.  Low voltage CMOS compatible power MOSFET for on-chip DC/DC converters , 2000, 12th International Symposium on Power Semiconductor Devices & ICs. Proceedings (Cat. No.00CH37094).

[3]  Mohamed N. Darwish,et al.  The dual-gate W-switched power MOSFET: a new concept for improving light load efficiency in DC/DC converters , 1997, Proceedings of 9th International Symposium on Power Semiconductor Devices and IC's.

[4]  Dongsheng Zhou,et al.  DPWM time resolution requirements for digitally controlled DC-DC converters , 2006, Twenty-First Annual IEEE Applied Power Electronics Conference and Exposition, 2006. APEC '06..

[5]  S. Yuvarajan,et al.  Performance analysis and signal processing in a current sensing power MOSFET (SENSEFET) , 1991, Conference Record of the 1991 IEEE Industry Applications Society Annual Meeting.

[6]  Wai Tung Ng,et al.  A Digitally Controlled DC-DC Converter Module with a Segmented Output Stage for Optimized Efficiency , 2006, 2006 IEEE International Symposium on Power Semiconductor Devices and IC's.

[7]  H. Nishio,et al.  High efficiency DC-DC converter chip size module with integrated soft ferrite , 2003, Digest of INTERMAG 2003. International Magnetics Conference (Cat. No.03CH37401).

[8]  Seth R. Sanders,et al.  Quantization resolution and limit cycling in digitally controlled PWM converters , 2003 .

[9]  Raymond B. Ridley,et al.  A new small-signal model for current-mode control , 1990 .

[10]  P.K.T. Mok,et al.  A monolithic current-mode CMOS DC-DC converter with on-chip current-sensing technique , 2004, IEEE Journal of Solid-State Circuits.

[11]  Wai Tung Ng,et al.  A low-power mixed-signal current-mode DC-DC converter using a one-bit /spl Delta//spl Sigma/ DAC , 2006, Twenty-First Annual IEEE Applied Power Electronics Conference and Exposition, 2006. APEC '06..

[12]  S. Chattopadhyay,et al.  A Digital Current-Mode Control Technique for DC–DC Converters , 2006, IEEE Transactions on Power Electronics.

[13]  Seth R. Sanders,et al.  A 4-μA quiescent-current dual-mode digitally controlled buck converter IC for cellular phone applications , 2004 .

[14]  D. Maksimovic,et al.  A digital current mode control technique for DC-DC converters , 2005, Twentieth Annual IEEE Applied Power Electronics Conference and Exposition, 2005. APEC 2005..

[15]  Y.-S. Jung.  Small-signal model-based design of digital current-mode control , 2005 .

[16]  Wai Tung Ng,et al.  A 1V buck converter IC with hybrid current-mode control and a charge-pump DAC , 2008, 2008 IEEE Power Electronics Specialists Conference.

[17]  Wen Wu,et al.  A wide-band T/R switch using enhanced compact Waffle MOSFETs , 2006, IEEE Microwave and Wireless Components Letters.

[18]  D. Maksimovic,et al.  Digital current-mode controller for DC-DC converters , 2005, Twentieth Annual IEEE Applied Power Electronics Conference and Exposition, 2005. APEC 2005..

[19]  Malik Elbuluk,et al.  Fundamentals of Power Electronics , 2013 .

[20]  Shahriar Mirabbasi,et al.  A 3GHz Switching DC-DC Converter Using Clock-Tree Charge-Recycling in 90nm CMOS with Integrated Output Filter , 2007, 2007 IEEE International Solid-State Circuits Conference. Digest of Technical Papers.

[21]  Youngkook Ahn,et al.  A 93.5% efficiency, 400-mA current-mode dc-dc buck converter with watchdog functions , 2009, 2009 International SoC Design Conference (ISOCC).

[22]  Cecil Deisch,et al.  Simple switching control method changes power converter into a current source , 1978, 1978 IEEE Power Electronics Specialists Conference.

[23]  D. Maksimovic,et al.  Modeling of Quantization Effects in Digitally Controlled DC–DC Converters , 2004, IEEE Transactions on Power Electronics.

[24]  Aleksandar Prodic,et al.  High-frequency digital PWM controller IC for DC-DC converters , 2003 .

[25]  A.V. Peterchev,et al.  A 4-/spl mu/a quiescent-current dual-mode digitally controlled buck converter IC for cellular phone applications , 2004, IEEE Journal of Solid-State Circuits.

[26]  Aleksandar Prodic,et al.  Digitally Controlled Low-Power DC-DC Converter with Instantaneous On-Line Efficiency Optimization , 2009, 2009 Twenty-Fourth Annual IEEE Applied Power Electronics Conference and Exposition.

[27]  Gabriel A. Rincón-Mora,et al.  An Accurate, Continuous, and Lossless Self-Learning CMOS Current-Sensing Scheme for Inductor-Based DC-DC Converters , 2007, IEEE Journal of Solid-State Circuits.