High step-up zero-voltage switching current-fed isolated pulse width modulation DC-DC converter

This study presents a new zero-voltage switching (ZVS) current-fed isolated pulse width modulation DC-DC converter. In this converter all switches turn on under zero-voltage zero-current switching and turn off under almost ZVS. Furthermore, the voltage spike across the main switch due to leakage inductance of isolating transformer is absorbed. Considering high efficiency and voltage gain of this converter, it is suitable for green generated systems such as fuel cells or photovoltaic systems. The proposed converter operating modes are analysed and theoretical waveforms are shown. The presented experimental results confirm the integrity of the proposed converter.

[1]  Selection of Snubbers and Clamps to Optimize the Design of Transistor Switching Converters , 1980, IEEE Transactions on Industry Applications.

[2]  I. Barbi,et al.  A new current-fed, isolated PWM DC-DC converter , 1996 .

[3]  Fred C. Lee,et al.  A soft-switched, full-bridge boost converter employing an active-clamp circuit , 1996, PESC Record. 27th Annual IEEE Power Electronics Specialists Conference.

[4]  Jung-Goo Cho,et al.  Novel zero-voltage-transition current-fed full-bridge PWM converter for single-stage power factor correction , 1998 .

[5]  Mutsuo Nakaoka,et al.  Performance evaluations of three-phase current-fed soft switching PWM converter with switched capacitor-type quasi-resonant snubber , 2001 .

[6]  Issa Batarseh,et al.  Full bridge ZCS PWM converter for high-voltage high-power applications , 2002 .

[7]  G. Moschopoulos,et al.  Single-stage ZVS PWM full-bridge converter , 2003 .

[8]  Tsorng-Juu Liang,et al.  Novel high-efficiency step-up converter , 2004 .

[9]  H.-L. Do.  Continuous-conduction-mode boost converter with reduced reverse-recovery loss , 2005 .

[10]  B. Lehman,et al.  Current-Fed Dual-Bridge DC–DC Converter , 2007, IEEE Transactions on Power Electronics.

[11]  Wuhua Li,et al.  ZVT interleaved boost converters for high-efficiency, high step-up DC-DC conversion , 2007 .

[12]  H. Farzanehfard,et al.  A soft switching flyback current-fed push pull Dc-Dc Converter with active clamp circuit , 2008, 2008 IEEE 2nd International Power and Energy Conference.

[13]  Stanislaw Jalbrzykowski,et al.  Current-Fed Resonant Full-Bridge Boost DC/AC/DC Converter , 2008, IEEE Transactions on Industrial Electronics.

[14]  P. Enjeti,et al.  A Three-Phase Current-Fed DC/DC Converter With Active Clamp for Low-DC Renewable Energy Sources , 2008, IEEE Transactions on Power Electronics.

[15]  Jung-Min Kwon,et al.  High Step-Up Active-Clamp Converter With Input-Current Doubler and Output-Voltage Doubler for Fuel Cell Power Systems , 2009 .

[16]  I. Barbi,et al.  A Three-Phase Current-Fed Push–Pull DC–DC Converter , 2009, IEEE Transactions on Power Electronics.

[17]  Eugene H. Kim,et al.  High step-up resonant push-pull converter with high efficiency , 2009 .

[18]  E. Adib,et al.  Zero-Voltage Transition Current-Fed Full-Bridge PWM Converter , 2009, IEEE Transactions on Power Electronics.