Results of Analytical Modeling of 3-D Machining Processes with Flat Faced Tools
暂无分享，去创建一个
[1] G. V. Stabler. The Fundamental Geometry of Cutting Tools , 1951 .
[2] I. Yellowley,et al. An upper-bound cutting model for oblique cutting tools with a nose radius , 1997 .
[3] P. Mathew,et al. Predicting the chip flow for nose radius tools under oblique machining conditions , 1993 .
[4] M. E. Merchant. Mechanics of the Metal Cutting Process. I. Orthogonal Cutting and a Type 2 Chip , 1945 .
[5] P.L.B. Oxley,et al. Allowing for Nose Radius Effects in Predicting the Chip Flow Direction and Cutting Forces in Bar Turning , 1987 .
[6] E.J.A. Armarego,et al. Oblique machining with a single cutting edge , 1964 .
[7] Hideaki Kudo,et al. Some new slip-line solutions for two-dimensional steady-state machining , 1965 .
[8] M. C. Shaw,et al. Mechanics of Machining: An Analytical Approach to Assessing Machinability , 1989 .
[9] E.J.A. Armarego,et al. A GENERIC MECHANICS OF CUTTING APPROACH TO PREDICTIVE TECHNOLOGICAL PERFORMANCE MODELING OF THE WIDE SPECTRUM OF MACHINING OPERATIONS , 1998 .
[10] Richard E. DeVor,et al. DEVELOPMENT OF MECHANISTIC MODELS FOR THE PREDICTION OF MACHINING PERFORMANCE: MODEL BUILDING METHODOLOGY , 1998 .
[11] P.L.B. Oxley,et al. Prediction of Chip Flow Direction and Cutting Forces in Oblique Machining with Nose Radius Tools , 1995 .
[12] M. Ortiz,et al. Modelling and simulation of high-speed machining , 1995 .