Thermal analysis of a building brick containing phase change material

This paper presents the thermal analysis of a building brick containing phase change material (PCM) to be used in hot climates. The objective of using the PCM is to utilize its high latent heat of fusion to reduce the heat gain by absorbing the heat in the bricks through the melting process before it reaches the indoor space. The considered model consists of bricks with cylindrical holes filled with PCM. The problem is solved in a two-dimensional space using the finite element method. The thermal effectiveness of the proposed brick-PCM system is evaluated by comparing the heat flux at the indoor surface to a wall without the PCM during typical working hours. A paramedic study is conducted to assess the effect of different design parameters, such as the PCM's quantity, type, and location in the brick. The results indicate that the heat gain is significantly reduced when the PCM is incorporated into the brick, and increasing the quantity of the PCM has a positive effect. PCM cylinders located at the centerline of the bricks shows the best performance.

[1]  Kamal Abdel Radi Ismail,et al.  PCM THERMAL INSULATION IN BUILDINGS , 1997 .

[2]  D. A. Neeper,et al.  Thermal dynamics of wallboard with latent heat storage , 2000 .

[3]  S. Alhajraf,et al.  Potential wind power generation in the State of Kuwait , 2005 .

[4]  M. Hadjieva,et al.  Composite salt-hydrate concrete system for building energy storage , 2000 .

[5]  Y. Çengel.  Heat Transfer: A Practical Approach , 1997 .

[6]  Amar M. Khudhair,et al.  A review on phase change energy storage: materials and applications , 2004 .

[7]  Mario A. Medina,et al.  Development of a thermally enhanced frame wall with phase‐change materials for on‐peak air conditioning demand reduction and energy savings in residential buildings , 2005 .

[8]  Uroš Stritih,et al.  Heat transfer enhancement in latent heat thermal storage system for buildings , 2003 .

[9]  K Darkwa,et al.  Simulation of an integrated PCM–wallboard system , 2003 .

[10]  D. Y. Goswami,et al.  Conjugate heat transfer analysis of fluid flow in a phase‐change energy storage unit , 1996 .

[11]  Jaroslav Mackerle,et al.  Finite elements and boundary elements applied in phase change, solidification and melting problems. A bibliography (1996–1998) , 1999 .

[12]  D. Feldman,et al.  Full scale thermal testing of latent heat storage in wallboard , 1996 .

[13]  Andreas K. Athienitis,et al.  Investigation of the Thermal Performance of a Passive Solar Test-Room with Wall Latent Heat Storage , 1997 .

[14]  Esam M. Alawadhi,et al.  Phase change process with free convection in a circular enclosure: numerical simulations , 2004 .

[15]  Abdul-Salam Al-Temeemi.  Climatic design techniques for reducing cooling energy consumption in Kuwaiti houses , 1995 .

[16]  Joseph Andrew Clarke,et al.  Numerical modelling and thermal simulation of PCM–gypsum composites with ESP-r , 2004 .